NewValidDumpsの問題集を購入したら、あなたの試験合格率が100%を保証いたします。もし試験に失敗したら、弊社が全額で返金いたします。 Ciscoの350-401資格問題集認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。NewValidDumpsを選ぶなら、君がCiscoの350-401資格問題集認定試験に合格するということできっと喜んでいます。 IT業界の中でたくさんの野心的な専門家がいって、IT業界の中でより一層頂上まで一歩更に近く立ちたくてCiscoの350-401資格問題集試験に参加して認可を得たくて、Cisco の350-401資格問題集試験が難度の高いので合格率も比較的低いです。

CCNP Enterprise 350-401 常々、時間とお金ばかり効果がないです。

CCNP Enterprise 350-401資格問題集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。 NewValidDumpsは多くの受験生を助けて彼らにCiscoの350-401 資格問題対応試験に合格させることができるのは我々専門的なチームがCiscoの350-401 資格問題対応試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの350-401 資格問題対応試験の資料を更新し続けています。

それはあなたが成功認定を助ける良いヘルパーですから、あなたはまだ何を待っているのですか。速く最新のNewValidDumpsのCiscoの350-401資格問題集トレーニング資料を取りに行きましょう。現在、IT業界での激しい競争に直面しているあなたは、無力に感じるでしょう。

Cisco 350-401資格問題集 - 暇の時間を利用して勉強します。

Ciscoの350-401資格問題集認定試験と言ったら、人々は迷っています。異なる考えがありますが、要約は試験が大変難しいことです。Ciscoの350-401資格問題集認定試験は確かに難しい試験ですが、NewValidDumps を選んだら、これは大丈夫です。NewValidDumpsのCiscoの350-401資格問題集試験トレーニング資料は受験生としてのあなたが欠くことができない資料です。それは受験生のために特別に作成したものですから、１００パーセントの合格率を保証します。信じないになら、NewValidDumpsのサイトをクリックしてください。購入する人々が大変多いですから、あなたもミスしないで速くショッピングカートに入れましょう。

多分、350-401資格問題集テスト質問の数が伝統的な問題の数倍である。Cisco　350-401資格問題集試験参考書は全ての知識を含めて、全面的です。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

NewValidDumpsのPECB ISO-IEC-27001-Lead-Auditor-KR問題集を使用することが最善の方法の一つです。 SAP C_ARSCC_2404 - この試験に合格すれば君の専門知識がとても強いを証明し得ます。 ServiceNow CSA - この試験が非常に困難ですが、実は試験の準備時に一生懸命である必要はありません。 きみはCiscoのMicrosoft SC-100認定テストに合格するためにたくさんのルートを選択肢があります。 CompTIA XK0-005 - この認証資格はあなたの仕事にたくさんのメリットを与えられ、あなたの昇進にも助けになることができます。

Updated: May 28, 2022