IT認証は同業種の欠くことができないものになりました。あなたはキャリアで良い昇進のチャンスを持ちたいのなら、NewValidDumpsのCiscoの350-401試験解説「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料を利用してCiscoの認証の証明書を取ることは良い方法です。現在、Ciscoの350-401試験解説認定試験に受かりたいIT専門人員がたくさんいます。 競争力が激しい社会において、IT仕事をする人は皆、我々NewValidDumpsの350-401試験解説を通して自らの幸せを筑く建筑士になれます。我が社のCiscoの350-401試験解説習題を勉強して、最も良い結果を得ることができます。 NewValidDumpsに会ったら、最高のトレーニング資料を見つけました。

350-401試験解説認定試験に合格することは難しいようですね。

我々社の練習問題は長年で350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験解説全真模擬試験トレーニング資料に研究している専業化チームによって編集されます。 もし不合格になったら、私たちは全額返金することを保証します。一回だけでCiscoの350-401 日本語認定対策試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。

Cisco　350-401試験解説試験参考書に疑問を持たれば、Cisco会社のウエブサイトから無料で350-401試験解説試験のためのデモをダウンロードできます。350-401試験解説試験参考書の高品質で350-401試験解説試験の受験者は弊社と長期的な協力関係を築いています。350-401試験解説試験参考書はお客様の試験のために最も役に立つ商品だとも言えます。

Cisco 350-401試験解説 - もし弊社の問題集を勉強してそれは簡単になります。

時間とお金の集まりより正しい方法がもっと大切です。Ciscoの350-401試験解説試験のために勉強していますなら、NewValidDumpsの提供するCiscoの350-401試験解説試験ソフトはあなたの選びの最高です。我々の目的はあなたにCiscoの350-401試験解説試験に合格することだけです。試験に失敗したら、弊社は全額で返金します。我々の誠意を信じてください。あなたが順調に試験に合格するように。

弊社の資料を使って、１００％に合格を保証いたします。NewValidDumpsはIT試験問題集を提供するウエブダイトで、ここによく分かります。

350-401 PDF DEMO:

QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

CiscoのOracle 1Z0-921試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoのOracle 1Z0-921試験に合格することができます。 多くのCiscoのCisco 300-420J認定試験を準備している受験生がいろいろなCisco 300-420J「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験についてサービスを提供するサイトオンラインがみつけたがNewValidDumpsはIT業界トップの専門家が研究した参考材料で権威性が高く、品質の高い教育資料で、一回に参加する受験者も合格するのを確保いたします。 弊社のHuawei H19-301_V3.0問題集はあなたにこのチャンスを全面的に与えられます。 CiscoのCompTIA CV0-003J認定試験に合格するためにたくさん方法があって、非常に少ないの時間とお金を使いのは最高で、NewValidDumpsが対応性の訓練が提供いたします。 また、SASInstitute A00-255問題集に疑問があると、メールで問い合わせてください。

Updated: May 28, 2022