問題集のdemoが無料で提供されますから、NewValidDumpsのサイトをクリックしてダウンロードしてください。NewValidDumpsの350-401試験対策問題集はあなたの一発合格を保証できる資料です。問題集の的中率はとても高いですから、この問題集だけで試験に合格することができます。 試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。あなたのニーズをよく知っていていますから、あなたに試験に合格する自信を与えます。 もしまだ試験に合格する自信を持っていないなら、ここで最高の試験参考書を推奨します。

CCNP Enterprise 350-401 できるだけ100％の通過率を保証使用にしています。

ブームになるIT技術業界でも、多くの人はこういう悩みがあるんですから、Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験対策の能力を把握できるのは欠かさせないない技能であると考えられます。 ただ、社会に入るIT卒業生たちは自分能力の不足で、350-401 日本語参考試験向けの仕事を探すのを悩んでいますか？それでは、弊社のCiscoの350-401 日本語参考練習問題を選んで実用能力を速く高め、自分を充実させます。その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調に350-401 日本語参考向けの会社に入ります。

我々社のCisco　350-401試験対策問題集を購入するかどうかと疑問があると、弊社NewValidDumpsの350-401試験対策問題集のサンプルをしてみるのもいいことです。試用した後、我々の350-401試験対策問題集はあなたを試験に順調に合格させると信じられます。なぜと言うのは、我々社の専門家は改革に応じて問題の更新と改善を続けていくのは出発点から勝つからです。

また、Cisco 350-401試験対策問題集は的中率が高いです。

多分、350-401試験対策テスト質問の数が伝統的な問題の数倍である。Cisco　350-401試験対策試験参考書は全ての知識を含めて、全面的です。そして、350-401試験対策試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。350-401試験対策試験参考書があれば,ほかの試験参考書を勉強する必要がないです。

簡単で順調にCisco 350-401試験対策認定試験を通すのは問題になりますが、NewValidDumpsはこの問題を解決できるよ。弊社の問題集はIT技術者がこつこつ研究して、正確で最新なもので君の350-401試験対策認定試験を簡単に通すことにいいトレーニングツールになりますよ。

350-401 PDF DEMO:

QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

CiscoのVMware 2V0-11.24の認定試験に合格すれば、就職機会が多くなります。 Huawei H12-111_V3.0 - 弊社の勉強の商品を選んで、多くの時間とエネルギーを節約こともできます。 IIA IIA-CIA-Part2 - あなたの全部な需要を満たすためにいつも頑張ります。 CiscoのSplunk SPLK-1005認定試験の合格証明書はあなたの仕事の上で更に一歩の昇進で生活条件が向上することが助けられます。 NewValidDumpsの専門家チームがCiscoのCheckPoint 156-561認証試験に対して最新の短期有効なトレーニングプログラムを研究しました。

Updated: May 28, 2022