NewValidDumpsは最も安い値段で正確性の高いCiscoの350-401日本語講座問題集を提供します。NewValidDumpsの学習教材はベストセラーになって、他のサイトをずっと先んじています。私たちのCiscoの350-401日本語講座問題集を使ったら、Ciscoの350-401日本語講座認定試験に合格できる。 もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoの350-401日本語講座試験のソフトウェアです。我々はあなたに提供するのは最新で一番全面的なCiscoの350-401日本語講座問題集で、最も安全な購入保障で、最もタイムリーなCiscoの350-401日本語講座試験のソフトウェアの更新です。 その権威性が高いと言えます。
CCNP Enterprise 350-401日本語講座 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。 さて、はやく試験を申し込みましょう。NewValidDumpsはあなたを助けることができますから、心配する必要がないですよ。
弊社が提供した問題集がほかのインターネットに比べて問題のカーバ範囲がもっと広くて対応性が強い長所があります。NewValidDumpsが持つべきなIT問題集を提供するサイトでございます。
NewValidDumpsのCiscoの350-401日本語講座試験のトレーニングキットはNewValidDumpsのIT技術専門家たちによって開発されたのです。そのデザインは当面の急速に変化するIT市場と密接な関係があります。NewValidDumpsのトレーニングはあなたを助けて継続的に発展している技術を利用して、問題を解決する能力を高めると同時に仕事についての満足度を向上させることができます。NewValidDumpsのCiscoの350-401日本語講座の認証したカバー率は100パーセントに達したのですから、弊社の問題と解答を利用する限り、あなたがきっと気楽に試験に合格することを保証します。
君がCiscoの350-401日本語講座問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの350-401日本語講座問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。
QUESTION NO: 1
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
Microsoft DP-203-KR - 最もプロな人々が注目しているIT専門家になりたかったら、後悔しないように速くショッピングカートを入れましょう。 弊社のソフトを使用して、ほとんどのお客様は難しいと思われているCiscoのMicrosoft MB-240J試験に順調に剛角しました。 Microsoft AZ-204 - NewValidDumpsがデザインしたトレーニングツールはあなたが一回で試験に合格することにヘルプを差し上げられます。 SAP E-BW4HANA214 - これをよくできるために、我々は全日24時間のサービスを提供します。 全てのIT専門人員はCiscoのIIA IIA-CIA-Part2-JPNの認定試験をよく知っていて、その難しい試験に受かることを望んでいます。
Updated: May 28, 2022
試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282 問
Cisco 350-401 勉強時間
ダウンロード
試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282 問
Cisco 350-401 試験解説問題
ダウンロード
試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282 問
Cisco 350-401 技術内容
ダウンロード