NewValidDumpsが提供したCiscoの350-401実際試験試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。NewValidDumpsは客様の要求を満たせていい評判をうけいたします。たくさんのひとは弊社の商品を使って、試験に順調に合格しました。 Ciscoの350-401実際試験の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoの350-401実際試験試験に一番信頼できるヘルプを提供します。Ciscoの350-401実際試験試験に失敗しても、我々はあなたの経済損失を減少するために全額で返金します。 今の人材が多い社会中に多くの業界は人材不足でたとえばIT業界はかなり技術的な人材が不足で、Ciscoの350-401実際試験認定試験はIT技術の認証試験の1つで、NewValidDumpsはCiscoの350-401実際試験認証試験に関するの特別な技術を持ってサイトでございます。

CCNP Enterprise 350-401 最もよくて最新で資料を提供いたします。

CCNP Enterprise 350-401実際試験 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) NewValidDumpsはあなたと苦楽を共にして、一緒に挑戦に直面します。 Cisco 350-401 試験合格攻略「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco 350-401 試験合格攻略証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。

誰もが成功する可能性があって、大切なのは選択することです。成功した方法を見つけるだけで、失敗の言い訳をしないでください。Ciscoの350-401実際試験試験に受かるのは実際にそんなに難しいことではないです。

Cisco 350-401実際試験 - 」とゴーリキーは述べました。

Ciscoの350-401実際試験試験に合格するのに、私たちは最も早い時間で合格するのを追求します。私たちはお客様のための利益を求めるのを追求します。私たちはNewValidDumpsです。NewValidDumpsはCiscoの350-401実際試験問題集の正確性と高いカバー率を保証します。Ciscoの350-401実際試験問題集を購入したら、NewValidDumpsは一年間で無料更新サービスを提供することができます。は

きっと望んでいるでしょう。では、常に自分自身をアップグレードする必要があります。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

しかし、CiscoのISC CC認定試験に合格するという夢は、NewValidDumpsに対して、絶対に掴められます。 Oracle 1z0-071-JPN - あなたは試験の最新バージョンを提供することを要求することもできます。 最も早い時間でCiscoのThe Open Group OG0-093J認定試験に合格したいなら、NewValidDumpsのCiscoのThe Open Group OG0-093J試験トレーニング資料を利用すればいいです。 NewValidDumpsはあなたが必要とするすべてのH3C GB0-343参考資料を持っていますから、きっとあなたのニーズを満たすことができます。 SAP C_TS4CO_2023 - 弊社の開発したソフトは非常に全面的です。

Updated: May 28, 2022