NewValidDumpsが提供した問題集を使用してIT業界の頂点の第一歩としてとても重要な地位になります。君の夢は1歩更に近くなります。資料を提供するだけでなく、Ciscoの200-301模擬解説集試験も一年の無料アップデートになっています。 それはNewValidDumpsの200-301模擬解説集問題集です。気楽に試験に合格したければ、はやく試しに来てください。 ソフトの問題集はNewValidDumpsが実際問題によって、テストの問題と解答を分析して出来上がりました。
もし君がCiscoの200-301 - Cisco Certified Network Associate Exam模擬解説集に参加すれば、良い学習のツルを選ぶすべきです。 NewValidDumpsのCiscoの200-301 試験解答試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。その権威性は言うまでもありません。
NewValidDumpsは100%の合格率を保証するだけでなく、1年間の無料なオンラインの更新を提供しております。最新の資源と最新の動態が第一時間にお客様に知らせいたします。何の問題があったらお気軽に聞いてください。
NewValidDumpsのウェブサイトをクリックしたら、NewValidDumpsに登録した人々が非常にたくさんいることに驚いたでしょう。実はこれは普通なことです。NewValidDumpsは毎日異なる受験生に様々なトレーニング資料を提供します。彼らは当社の資料を利用してから試験に受かりました。これは当社が提供したCiscoの200-301模擬解説集トレーニング資料が本当に効果的なものということを証明しました。もしあなたも試験に合格したいのなら、NewValidDumpsをミスしないでください。NewValidDumpsはきっとあなたのニーズを満たせますから。
現在IT技術会社に通勤しているあなたは、Ciscoの200-301模擬解説集試験認定を取得しましたか?200-301模擬解説集試験認定は給料の増加とジョブのプロモーションに役立ちます。短時間で200-301模擬解説集試験に一発合格したいなら、我々社のCiscoの200-301模擬解説集資料を参考しましょう。
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
Amazon SOA-C02-KR - それはあなたがいつでも最新の試験資料を持てるということです。 だから、我々社は力の限りで弊社のCisco Scrum SSM-JPN試験資料を改善し、改革の変更に応じて更新します。 IIA IIA-CIA-Part2-KR - この資料を手に入れたら、楽に試験の準備をすることができます。 あなたはSAP C-THR81-2411試験に不安を持っていますか?SAP C-THR81-2411参考資料をご覧下さい。 Juniper JN0-252 - 彼らの成果はあなたが試験に合格することを助けるだけでなく、あなたにもっと美しい明日を与えることもできます。
Updated: May 28, 2022
試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-12-26
問題と解答:全 990 問
Cisco 200-301 模擬問題
ダウンロード
試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-12-26
問題と解答:全 990 問
Cisco 200-301 対策学習
ダウンロード
試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-12-26
問題と解答:全 990 問
Cisco 200-301 全真問題集
ダウンロード