人生はさまざまな試しがある、人生の頂点にかからないけど、刺激のない生活に変化をもたらします。あなたは我々社の提供する質高いCisco 200-301テスト難易度問題集を使用して、試験に参加します。もし無事に200-301テスト難易度試験に合格したら、あなたはもっと自信になって、更なる勇気でやりたいことをしています。 自分のIT業界での発展を希望したら、Ciscoの200-301テスト難易度試験に合格する必要があります。Ciscoの200-301テスト難易度試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoの200-301テスト難易度試験に合格することができます。 また、我々NewValidDumpsは量豊かのCisco 200-301テスト難易度試験資料を提供しますし、ソフト版であなたにCisco 200-301テスト難易度試験の最も現実的な環境をシミュレートさせます。
CCNA 200-301テスト難易度 - Cisco Certified Network Associate Exam NewValidDumps を選択して100%の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。 NewValidDumpsはCiscoの200-301 受験記認定試験「Cisco Certified Network Associate Exam」に向けてもっともよい問題集を研究しています。もしほかのホームページに弊社みたいな問題集を見れば、あとでみ続けて、弊社の商品を盗作することとよくわかります。
あなたはインターネットでCiscoの200-301テスト難易度認証試験の練習問題と解答の試用版を無料でダウンロードしてください。そうしたらあなたはNewValidDumpsが用意した問題集にもっと自信があります。早くNewValidDumpsの問題集を君の手に入れましょう。
NewValidDumpsにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 200-301テスト難易度認証試験に参加する方に対して問題集を研究続けています。君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにNewValidDumpsを選択してください。NewValidDumpsはまた一年間に無料なサービスを更新いたします。
きっと試験に合格しますよ。あなたはまだ何を待っているのですか。
QUESTION NO: 1
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 2
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 3
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 4
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
NewValidDumps のCiscoのAmazon DVA-C02-KR問題集はシラバスに従って、それにAmazon DVA-C02-KR認定試験の実際に従って、あなたがもっとも短い時間で最高かつ最新の情報をもらえるように、弊社はトレーニング資料を常にアップグレードしています。 NewValidDumpsのCiscoのSalesforce DEX-450J勉強資料は問題と解答を含めています。 Amazon AIF-C01-JPN - あなたに成功に近づいて、夢の楽園に一歩一歩進めさせられます。 Microsoft AZ-305J - 当社の資料はあなたがIT専門家になるように特別に受験生の皆さんのために作成したものです。 ISACA CRISC - 試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。
Updated: May 28, 2022
試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2025-01-15
問題と解答:全 990 問
Cisco 200-301 真実試験
ダウンロード
試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2025-01-15
問題と解答:全 990 問
Cisco 200-301 試験攻略
ダウンロード
試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2025-01-15
問題と解答:全 990 問
Cisco 200-301 クラムメディア
ダウンロード