弊社のNewValidDumpsで無料でNetwork ApplianceのNS0-180関連資格試験対応ソフトのデモを直ちにダウンロードできます。我々豊富な経験があるグループはあなたに一番信頼できるNetwork ApplianceのNS0-180関連資格試験対応試験のための資料を提供いたします。我々係員は全日24時間で待っていますから、何か疑問があれば、お問い合わせを期待しています。 近年、IT領域で競争がますます激しくなります。IT認証は同業種の欠くことができないものになりました。 あなたは高効率の復習とNetwork ApplianceのNS0-180関連資格試験対応試験の成功を経験する必要があればいいです。

NS0-180関連資格試験対応認定試験に合格することは難しいようですね。

NCSIE NS0-180関連資格試験対応 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP あなたより優れる人は存在している理由は彼らはあなたの遊び時間を効率的に使用できることです。 NewValidDumpsのNetwork ApplianceのNS0-180 模試エンジン問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。もし不合格になったら、私たちは全額返金することを保証します。

弊社のNetwork Appliance　NS0-180関連資格試験対応問題集を使用した後、NS0-180関連資格試験対応試験に合格するのはあまりに難しくないことだと知られます。我々NewValidDumps提供するNS0-180関連資格試験対応問題集を通して、試験に迅速的にパースする技をファンドできます。あなたのご遠慮なく購買するために、弊社は提供する無料のNetwork Appliance　NS0-180関連資格試験対応問題集デーモをダウンロードします。

Network Appliance NS0-180関連資格試験対応 - 弊社の商品が好きなのは弊社のたのしいです。

NewValidDumpsを選択したら、成功が遠くではありません。NewValidDumpsが提供するNetwork ApplianceのNS0-180関連資格試験対応認証試験問題集が君の試験に合格させます。テストの時に有効なツルが必要でございます。

NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。

NS0-180 PDF DEMO:

QUESTION NO: 1
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

QUESTION NO: 2
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 3
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 4
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 5
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

Salesforce B2C-Commerce-Architect - あなたに予想外の良い効果を見せられますから。 あなたはインターネットでNetwork ApplianceのMicrosoft MB-230認証試験の練習問題と解答の試用版を無料でダウンロードしてください。 Cisco 350-601J - あなたが首尾よく試験に合格するように、我々は最も有利な価格と最高のクオリティーを提供して差し上げます。 Juniper JN0-280 - NewValidDumpsはまた一年間に無料なサービスを更新いたします。 そうしたらNewValidDumpsのNetwork ApplianceのPECB ISO-IEC-27001-Lead-Auditor試験に合格することができるようになります。

Updated: May 28, 2022