あなたのNetwork ApplianceのNS0-180資格取得試験に参加する圧力を減ってあなたの効率を高めるのは我々の使命だと思います。Network ApplianceのNS0-180資格取得試験のために不安なのですか。弊社のソフトは買うたるかどうかまだ疑問がありますか。 我々NewValidDumpsはNetwork ApplianceのNS0-180資格取得試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確のNS0-180資格取得試験問題集を開発するのに準備します。 そうでない場合、今回使用してからあなたがNewValidDumpsを必要な選択肢として使用できるようになります。

NCSIE NS0-180 弊社の量豊かの備考資料はあなたを驚かさせます。

ITの専門者はNetwork ApplianceのNS0-180 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP資格取得認定試験があなたの願望を助けって実現できるのがよく分かります。 我々社のNetwork Appliance　NS0-180 資格難易度問題集とサーブすが多くの人々に認められます。最近、Network Appliance　NS0-180 資格難易度問題集は通過率が高いなので大人気になります。

NewValidDumpsの専門家チームが君の需要を満たすために自分の経験と知識を利用してNetwork ApplianceのNS0-180資格取得認定試験対策模擬テスト問題集が研究しました。模擬テスト問題集と真実の試験問題がよく似ています。一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。

それはNewValidDumpsのNetwork Appliance NS0-180資格取得問題集です。

NewValidDumpsのNetwork ApplianceのNS0-180資格取得認証試験について最新な研究を完成いたしました。無料な部分ダウンロードしてください。きっと君に失望させないと信じています。最新Network ApplianceのNS0-180資格取得認定試験は真実の試験問題にもっとも近くて比較的に全面的でございます。

NewValidDumpsは君にとってベストな選択になります。ここには、私たちは君の需要に応じます。

NS0-180 PDF DEMO:

QUESTION NO: 1
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 2
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 3
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 4
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

QUESTION NO: 5
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

Network ApplianceのAdobe AD0-E123認証試験は世界でどの国でも承認されて、すべての国が分け隔てをしないの試験です。 NewValidDumpsのNetwork ApplianceのSalesforce Salesforce-Data-Cloud-JPN試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 Huawei H20-422_V1.0 - あなたに他の同じ値段の製品を無料に送って差し上げます。 Palo Alto Networks PCNSE - 時間とお金の集まりより正しい方法がもっと大切です。 Huawei H13-313_V1.0 - そのような人になりたいのですか。

Updated: May 28, 2022