NewValidDumpsの専門家チームが彼ら自分の知識と経験を使って多くの人の夢が実現させるIT関連の認証試験の問題集を研究し続けています。NewValidDumpsが提供したNetwork ApplianceのNS0-180認定デベロッパー試験問題と解答が真実の試験の練習問題と解答は最高の相似性があります。NewValidDumpsがあなたの夢が実現させるサイトでございます。 Network ApplianceのNS0-180認定デベロッパー認定試験は実は技術専門家を認証する試験です。Network ApplianceのNS0-180認定デベロッパー認定試験はIT人員が優れたキャリアを持つことを助けられます。 NewValidDumpsが提供したのオンライン商品がIT業界では品質の高い学習資料、受験生の必要が満足できるサイトでございます。

NCSIE NS0-180 それはあなたが夢を実現することを助けられます。

Network ApplianceのNS0-180 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP認定デベロッパー認証試験はIT業界にとても重要な地位があることがみんなが、たやすくその証本をとることはではありません。 IT業種で仕事しているあなたは、夢を達成するためにどんな方法を利用するつもりですか。実際には、IT認定試験を受験して認証資格を取るのは一つの良い方法です。

NewValidDumps のNetwork ApplianceのNS0-180認定デベロッパー問題集は１００パーセント検証とテストを通過したもので、認定試験に合格する専門的な指導者です。NewValidDumps のNetwork ApplianceのNS0-180認定デベロッパー「NetApp Certified Storage Installation Engineer, Clustered Data ONTAP」練習問題集と解答は実践の検査に合格したソフトウェアで、最も受験生に合うトレーニングツールです。NewValidDumpsで、あなたは一番良い準備資料を見つけられます。

Network Appliance NS0-180認定デベロッパー - 試験に合格する自信を持たなくても大丈夫です。

暇な時間だけでNetwork ApplianceのNS0-180認定デベロッパー試験に合格したいのですか。我々の提供するPDF版のNetwork ApplianceのNS0-180認定デベロッパー試験の資料はあなたにいつでもどこでも読めさせます。我々もオンライン版とソフト版を提供します。すべては豊富な内容があって各自のメリットを持っています。あなたは各バーションのNetwork ApplianceのNS0-180認定デベロッパー試験の資料をダウンロードしてみることができ、あなたに一番ふさわしいバーションを見つけることができます。

これはあなたが一回で試験に合格することを保証できる問題集です。成功することが大変難しいと思っていますか。

NS0-180 PDF DEMO:

QUESTION NO: 1
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 2
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 3
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

QUESTION NO: 4
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 5
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

我々NewValidDumpsはNetwork ApplianceのEMC D-VXR-DY-01試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。 はやくNewValidDumpsのSalesforce ADM-201問題集を入手しましょう。 ほんとんどお客様は我々NewValidDumpsのNetwork Appliance　Microsoft DP-203問題集を使用してから試験にうまく合格しましたのは弊社の試験資料の有効性と信頼性を説明できます。 NewValidDumpsのNetwork ApplianceのSalesforce Mobile-Solutions-Architecture-Designerの試験問題と解答は当面の市場で最も徹底的な正確的な最新的な模擬テストです。 この問題集の合格率は高いので、多くのお客様からCisco 300-435J問題集への好評をもらいました。

Updated: May 28, 2022