IT認証は同業種の欠くことができないものになりました。あなたはキャリアで良い昇進のチャンスを持ちたいのなら、NewValidDumpsのNetwork ApplianceのNS0-180試験復習「NetApp Certified Storage Installation Engineer, Clustered Data ONTAP」試験トレーニング資料を利用してNetwork Applianceの認証の証明書を取ることは良い方法です。現在、Network ApplianceのNS0-180試験復習認定試験に受かりたいIT専門人員がたくさんいます。 おそらく、君たちは私たちのNS0-180試験復習試験資料について何も知らないかもしれません。でも、私たちのNS0-180試験復習試験資料のデモをダウンロードしてみると、全部わかるようになります。 NewValidDumpsに会ったら、最高のトレーニング資料を見つけました。

それはNewValidDumpsのNS0-180試験復習問題集です。

NCSIE NS0-180試験復習 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP ソフトの問題集はNewValidDumpsが実際問題によって、テストの問題と解答を分析して出来上がりました。 もし不合格になったら、私たちは全額返金することを保証します。一回だけでNetwork ApplianceのNS0-180 試験問題集試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。

もし君がNetwork ApplianceのNS0-180試験復習に参加すれば、良い学習のツルを選ぶすべきです。Network ApplianceのNS0-180試験復習認定試験はIT業界の中でとても重要な認証試験で、合格するために良い訓練方法で準備をしなければなりません。。

Network Appliance NS0-180試験復習 - 何の問題があったらお気軽に聞いてください。

時間とお金の集まりより正しい方法がもっと大切です。Network ApplianceのNS0-180試験復習試験のために勉強していますなら、NewValidDumpsの提供するNetwork ApplianceのNS0-180試験復習試験ソフトはあなたの選びの最高です。我々の目的はあなたにNetwork ApplianceのNS0-180試験復習試験に合格することだけです。試験に失敗したら、弊社は全額で返金します。我々の誠意を信じてください。あなたが順調に試験に合格するように。

あなたはきっとNetwork ApplianceのNS0-180試験復習試験に合格できますから。現在でNetwork ApplianceのNS0-180試験復習試験を受かることができます。

NS0-180 PDF DEMO:

QUESTION NO: 1
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 2
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

QUESTION NO: 3
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 4
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 5
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

Network ApplianceのCompTIA DA0-001試験を準備しているあなたに試験に合格させるために、我々NewValidDumpsは模擬試験ソフトを更新し続けています。 世界各地の人々はNetwork ApplianceのFortinet NSE5_FMG-7.2-JPN認定試験が好きです。 弊社のOracle 1z1-084問題集はあなたにこのチャンスを全面的に与えられます。 SAP C_TS462_2022-KR - NewValidDumpsは毎日異なる受験生に様々なトレーニング資料を提供します。 現在IT技術会社に通勤しているあなたは、Network ApplianceのSAP C_S4CS_2402試験認定を取得しましたか？SAP C_S4CS_2402試験認定は給料の増加とジョブのプロモーションに役立ちます。

Updated: May 28, 2022