NewValidDumpsの専門家チームが君の需要を満たすために自分の経験と知識を利用してNetwork ApplianceのNS0-180最新対策問題認定試験対策模擬テスト問題集が研究しました。模擬テスト問題集と真実の試験問題がよく似ています。一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。 NewValidDumpsの問題と解答は初めに試験を受けるあなたが気楽に成功することを助けるだけではなく、あなたの貴重な時間を節約することもできます。NewValidDumpsのNetwork ApplianceのNS0-180最新対策問題の試験問題と解答はあなたが受験する前にすべての必要とした準備資料を提供しています。 NewValidDumpsのNetwork ApplianceのNS0-180最新対策問題の試験問題は同じシラバスに従って、実際のNetwork ApplianceのNS0-180最新対策問題認証試験にも従っています。

それはNewValidDumpsのNS0-180最新対策問題問題集です。

NCSIE NS0-180最新対策問題 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP この問題集をミスすればあなたの大きな損失ですよ。 NewValidDumpsは君にとってベストな選択になります。ここには、私たちは君の需要に応じます。

この問題集は絶対あなたがずっと探しているものです。これは受験生の皆さんのために特別に作成し出された試験参考書です。この参考書は短い時間で試験に十分に準備させ、そして楽に試験に合格させます。

Network Appliance NS0-180最新対策問題 - 我々の誠意を信じてください。

NewValidDumpsはきっとご存じしています。それは現在、市場上でNetwork Appliance のNS0-180最新対策問題認定試験に合格する率が一番高いからです。あなたはうちのNetwork ApplianceのNS0-180最新対策問題問題集を購入する前に、一部分のフリーな試験問題と解答をダンロードして、試用してみることができます。ご利用によってで、うちのNetwork ApplianceのNS0-180最新対策問題問題集は正確性が高いです。Network ApplianceのNS0-180最新対策問題問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。

自分のIT業界での発展を希望したら、Network ApplianceのNS0-180最新対策問題試験に合格する必要があります。Network ApplianceのNS0-180最新対策問題試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはNetwork ApplianceのNS0-180最新対策問題試験に合格することができます。

NS0-180 PDF DEMO:

QUESTION NO: 1
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 2
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 3
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 4
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

QUESTION NO: 5
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

EMC D-SNC-DY-00 - あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。 Salesforce Public-Sector-Solutions - 心はもはや空しくなく、生活を美しくなります。 Network ApplianceのCisco 200-301J試験を準備するのは残念ですが、合格してからあなたはITに関する仕事から美しい未来を持っています。 短時間でOracle 1Z0-084試験に一発合格したいなら、我々社のNetwork ApplianceのOracle 1Z0-084資料を参考しましょう。 Salesforce ANC-201 - 弊社の無料デモをダウンロードしてあなたはもっと真実に体験することができます。

Updated: May 28, 2022