NS0-180日本語学習内容 資格取得

全てのIT専門人員はNetwork ApplianceのNS0-180日本語学習内容の認定試験をよく知っていて、その難しい試験に受かることを望んでいます。Network ApplianceのNS0-180日本語学習内容の認定試験の認可を取ったら、あなたは望むキャリアを得ることができるようになります。NewValidDumpsのNetwork ApplianceのNS0-180日本語学習内容試験トレーニング資料を利用したら、望むことを取得できます。 暇な時間だけでNetwork ApplianceのNS0-180日本語学習内容試験に合格したいのですか。我々の提供するPDF版のNetwork ApplianceのNS0-180日本語学習内容試験の資料はあなたにいつでもどこでも読めさせます。 NewValidDumps は世界的によく知られているサイトです。

NS0-180日本語学習内容問題集を利用して試験に合格できます。

そうすると、NS0-180 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP日本語学習内容問題集の品質を知らないままに問題集を購入してから後悔になることを避けることができます。 NewValidDumpsにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が100%にまで達します。弊社のみたいなウエブサイトが多くても、彼たちは君の学習についてガイドやオンラインサービスを提供するかもしれないが、弊社はそちらにより勝ちます。

しかも、楽に試験に合格することができます。IT領域でより大きな進歩を望むなら、NS0-180日本語学習内容認定試験を受験する必要があります。IT試験に順調に合格することを望むなら、NewValidDumpsのNS0-180日本語学習内容問題集を使用する必要があります。

Network Appliance NS0-180日本語学習内容 - 近年、IT領域で競争がますます激しくなります。

競争力が激しい社会において、IT仕事をする人は皆、我々NewValidDumpsのNS0-180日本語学習内容を通して自らの幸せを筑く建筑士になれます。我が社のNetwork ApplianceのNS0-180日本語学習内容習題を勉強して、最も良い結果を得ることができます。我々のNS0-180日本語学習内容習題さえ利用すれば試験の成功まで近くなると考えられます。

NewValidDumpsのNetwork ApplianceのNS0-180日本語学習内容試験トレーニング資料は豊富な知識と経験を持っているIT専門家に研究された成果で、正確度がとても高いです。NewValidDumpsに会ったら、最高のトレーニング資料を見つけました。

NS0-180 PDF DEMO:

QUESTION NO: 1
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

QUESTION NO: 2
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 3
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 4
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 5
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

弊社NewValidDumpsのNetwork Appliance NS0-521問題集は必ずあなたの成功へ道の秘訣です。 SAP C_S4CPR_2402 - これは試験の準備をするために非常に効率的なツールですから。 AACN CCRN-Adult - 別の人の言い回しより自分の体験感じは大切なことです。 SAP C_ABAPD_2309認定試験に合格することは難しいようですね。 他の人に先立ってNetwork Appliance Microsoft SC-200J認定資格を得るために、今から勉強しましょう。

Updated: May 28, 2022

NS0-180日本語学習内容 & NS0-180試験解説、NS0-180資料勉強

PDF問題と解答

試験コード:NS0-180
試験名称:NetApp Certified Storage Installation Engineer, Clustered Data ONTAP
最近更新時間:2024-06-15
問題と解答:全 65
Network Appliance NS0-180 更新版

  ダウンロード


 

模擬試験

試験コード:NS0-180
試験名称:NetApp Certified Storage Installation Engineer, Clustered Data ONTAP
最近更新時間:2024-06-15
問題と解答:全 65
Network Appliance NS0-180 模擬体験

  ダウンロード


 

オンライン版

試験コード:NS0-180
試験名称:NetApp Certified Storage Installation Engineer, Clustered Data ONTAP
最近更新時間:2024-06-15
問題と解答:全 65
Network Appliance NS0-180 試験情報

  ダウンロード


 

NS0-180 学習体験談

NS0-180 受験料 関連認定