NewValidDumpsはNetwork ApplianceのNS0-180日本語問題集認定試験について開発された問題集がとても歓迎されるのはここで知識を得るだけでなく多くの先輩の経験も得ます。試験に良いの準備と自信がとても必要だと思います。使用して私たちNewValidDumpsが提供した対応性練習問題が君にとってはなかなかよいサイトだと思います。 NewValidDumpsはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。あなたが自分のキャリアでの異なる条件で自身の利点を発揮することを助けられます。 NewValidDumpsの商品の最大の特徴は20時間だけ育成課程を通して楽々に合格できます。

NCSIE NS0-180 早速買いに行きましょう。

Network ApplianceのNS0-180 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP日本語問題集の認定試験に受かることはIT業種に従事している皆さんの夢です。 それは正確性が高くて、カバー率も広いです。あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

NewValidDumpsにはすごいトレーニング即ち Network ApplianceのNS0-180日本語問題集試験トレーニング資料があります。これはIT職員の皆が熱望しているものです。あなたが試験に合格することを助けられますから。

Network Appliance NS0-180日本語問題集 - アフターサービスは会社を評価する重要な基準です。

今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。NewValidDumpsが提供したのオンライン商品がIT業界では品質の高い学習資料、受験生の必要が満足できるサイトでございます。

お客様に自分に一番ふさわしいNetwork ApplianceのNS0-180日本語問題集試験の復習方式を提供するために、我々はNetwork ApplianceのNS0-180日本語問題集の資料の3つのバーションを提供します。PDF、オンライン版とソフト版です。

NS0-180 PDF DEMO:

QUESTION NO: 1
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 2
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 3
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 4
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

QUESTION NO: 5
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

Nutanix NCP-MCI-6.5 - 試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。 返金を願うのに対して、お客様はSalesforce Marketing-Cloud-Email-Specialist-JPNに合格しない成績書を弊社に送付して、弊社は確認の後、支払い金額を全部返済します。 NewValidDumpsのNetwork ApplianceのSymantec 250-587試験問題資料は質が良くて値段が安い製品です。 我々社NewValidDumpsは試験政策の変化に応じて、Network ApplianceのDocker DCA問題集をタイムリーに更新しています。 WGU Introduction-to-IT - 優れたキャリアを持ったら、社会と国のために色々な利益を作ることができて、国の経済が継続的に発展していることを進められるようになります。

Updated: May 28, 2022