あなたは無料で642-997試験関連赤本復習教材をダウンロードしたいですか？もちろん、回答ははいです。だから、あなたはコンピューターでCiscoのウエブサイトを訪問してください。そうすれば、あなたは簡単に642-997試験関連赤本復習教材のデモを無料でダウンロードできます。 我々はあなたに向いて適当の資料を選びます。しかも、サイトでテストデータの一部は無料です。 もし合格しないと、われは全額で返金いたします。

CCNP Data Center 642-997 夢を持ったら実現するために頑張ってください。

CCNP Data Center 642-997試験関連赤本 - Implementing Cisco Data Center Unified Fabric (DCUFI) 私たちはお客様のための利益を求めるのを追求します。 最近、Ciscoの642-997 合格率試験は非常に人気のある認定試験です。あなたもこの試験の認定資格を取得したいのですか。

しかし、Ciscoの642-997試験関連赤本認定試験に合格するという夢は、NewValidDumpsに対して、絶対に掴められます。NewValidDumpsは親切なサービスで、Ciscoの642-997試験関連赤本問題集が質の良くて、Ciscoの642-997試験関連赤本認定試験に合格する率も１００パッセントになっています。NewValidDumpsを選ぶなら、私たちは君の認定試験に合格するのを保証します。

Cisco 642-997試験関連赤本 - 弊社の開発したソフトは非常に全面的です。

NewValidDumpsのCiscoの642-997試験関連赤本試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。君がCiscoの642-997試験関連赤本問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの642-997試験関連赤本問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。

弊社のホームページでソフトのデモをダウンロードして利用してみます。我々の商品はあなたの認可を得られると希望します。

642-997 PDF DEMO:

QUESTION NO: 1
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 2
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 3
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
If vPC peer keepalives are used between vPC peers, which VRF is used by default?
A. management
B. default
C. The user must dedicate a VRF for keepalives.
D. system
Answer: A

ASQ CQE-KR - すべてのことの目的はあなたに安心に試験に準備さされるということです。 CiscoのMicrosoft DP-203-KR試験に参加するのを決めるとき、あなたは強い心を持っているのを証明します。 我々のCiscoのDatabricks Databricks-Certified-Data-Engineer-Associateソフトを利用してお客様の高通過率及び我々の技術の高いチームで、我々は自信を持って我々NewValidDumpsは専門的なのだと言えます。 我々Salesforce Marketing-Cloud-Developer-JPN資料はIT認定試験の改革に準じて更新していますから、お客様は改革での問題変更に心配するは全然ありません。 SAP C-THR70-2404 - すべては豊富な内容があって各自のメリットを持っています。

Updated: May 28, 2022