これはCiscoの最も重要な試験の一つで、業界全体に認証された資格です。近年、IT技術の急速な発展に伴って、IT技術を勉強し始める人がますます多くなっています。そこで、IT業界で働く人も多くなっています。 世の中に去年の自分より今年の自分が優れていないのは立派な恥です。それで、IT人材として毎日自分を充実して、642-997試験解説問題集を学ぶ必要があります。 最新の642-997試験解説試験問題を知りたい場合、試験に合格したとしてもNewValidDumpsは無料で問題集を更新してあげます。

Ciscoの642-997試験解説試験は国際的に認可られます。

CCNP Data Center 642-997試験解説 - Implementing Cisco Data Center Unified Fabric (DCUFI) もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。 Ciscoの642-997 専門トレーリング資格認定証明書を取得したいなら、我々の問題集を入手してください。我々NewValidDumpsから一番質高い642-997 専門トレーリング問題集を見つけられます。

認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoの642-997試験解説試験を研究していますから、Ciscoの642-997試験解説認定試験に受かりたかったら、NewValidDumpsのサイトをクッリクしてください。あなたに成功に近づいて、夢の楽園に一歩一歩進めさせられます。NewValidDumps Ciscoの642-997試験解説試験トレーニング資料というのは一体なんでしょうか。

Cisco 642-997試験解説 - できるだけ100％の通過率を保証使用にしています。

現在の社会の中で優秀なIT人材が揃て、競争も自ずからとても大きくなって、だから多くの方はITに関する試験に参加してIT業界での地位のために奮闘しています。642-997試験解説はCiscoの一つ重要な認証試験で多くのIT専門スタッフが認証される重要な試験です。

ただ、社会に入るIT卒業生たちは自分能力の不足で、642-997試験解説試験向けの仕事を探すのを悩んでいますか？それでは、弊社のCiscoの642-997試験解説練習問題を選んで実用能力を速く高め、自分を充実させます。その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調に642-997試験解説向けの会社に入ります。

642-997 PDF DEMO:

QUESTION NO: 1
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 2
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

QUESTION NO: 3
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

Amazon SAP-C02-KR - ですから、弊社のトレーニング製品はあなたが試験に合格することを助けにならなかったら、全額で返金することを保証します。 NewValidDumpsのCisco　ASQ CQE問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。 Fortinet NSE6_FSW-7.2-JPN - 認証試験に合格したら、あなたはIT領域で国際的な価値を表すことができます。 Cisco 300-430 - IT職員のあなたは毎月毎月のあまり少ない給料を持っていますが、暇の時間でひたすら楽しむんでいいですか。 Microsoft MB-310 - 今年で一番人気があるIT認証試験に申し込みましたか。

Updated: May 28, 2022