Ciscoの642-997無料問題試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でNewValidDumpsは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。 うちのCiscoの642-997無料問題試験トレーニング資料を購入する前に、NewValidDumpsのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。君がうちの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。 IT業界ではさらに強くなるために強い専門知識が必要です。

CCNP Data Center 642-997 それは確かに君の試験に役に立つとみられます。

あなたは自分の望ましいCisco 642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)無料問題問題集を選らんで、学びから更なる成長を求められます。 が、サイトに相関する依頼できる保証が何一つありません。ここで私が言いたいのはNewValidDumpsのコアバリューです。

現在IT技術会社に通勤しているあなたは、Ciscoの642-997無料問題試験認定を取得しましたか？642-997無料問題試験認定は給料の増加とジョブのプロモーションに役立ちます。短時間で642-997無料問題試験に一発合格したいなら、我々社のCiscoの642-997無料問題資料を参考しましょう。また、642-997無料問題問題集に疑問があると、メールで問い合わせてください。

それはNewValidDumpsのCisco 642-997無料問題問題集です。

NewValidDumps のCiscoの642-997無料問題問題集はシラバスに従って、それに642-997無料問題認定試験の実際に従って、あなたがもっとも短い時間で最高かつ最新の情報をもらえるように、弊社はトレーニング資料を常にアップグレードしています。弊社の642-997無料問題のトレーニング資料を買ったら、一年間の無料更新サービスを差し上げます。もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。

ショートカットを選択し、テクニックを使用するのはより良く成功できるからです。642-997無料問題認定試験に一発合格できる保障を得たいなら、NewValidDumps の642-997無料問題問題集はあなたにとってユニークな、しかも最良の選択です。

642-997 PDF DEMO:

QUESTION NO: 1
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 2
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 3
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 4
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 5
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

CiscoのHP HPE0-V27試験トレーニングソースを提供するサイトがたくさんありますが、NewValidDumpsは最実用な資料を提供します。 Salesforce Heroku-Architect - もし学習教材は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。 NewValidDumpsのCiscoのWGU Cybersecurity-Architecture-and-Engineering試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。 あなたはNewValidDumpsのCiscoのCisco 200-301J問題集を購入した後、私たちは一年間で無料更新サービスを提供することができます。 NewValidDumpsのCiscoのCisco 300-445試験トレーニング資料は最高のトレーニング資料です。

Updated: May 28, 2022