また、NewValidDumpsのCiscoの642-997模擬対策試験トレーニング資料が信頼できるのは多くの受験生に証明されたものです。NewValidDumpsのCiscoの642-997模擬対策試験トレーニング資料を利用したらきっと成功できますから、NewValidDumpsを選ばない理由はないです。試験の準備をするためにNewValidDumpsのCiscoの642-997模擬対策試験トレーニング資料を買うのは冒険的行為と思ったとしたら、あなたの人生の全てが冒険なことになります。 素晴らしい試験参考書です。642-997模擬対策認定試験の難しさで近年、資格認定試験に合格した受験生はますます少なくなっていたと良く知られます。 それは NewValidDumpsの642-997模擬対策問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。

CCNP Data Center 642-997 まだ何を待っていますか。

NewValidDumpsのシニア専門家チームはCiscoの642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)模擬対策試験に対してトレーニング教材を研究できました。 それは正確性が高くて、カバー率も広いです。あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

Ciscoの642-997模擬対策は専門知識と情報技術の検査として認証試験で、NewValidDumpsはあなたに一日早くCiscoの認証試験に合格させて、多くの人が大量の時間とエネルギーを費やしても無駄になりました。NewValidDumpsにその問題が心配でなく、わずか20時間と少ないお金をを使って楽に試験に合格することができます。NewValidDumpsは君に対して特別の訓練を提供しています。

Cisco 642-997模擬対策 - NewValidDumpsを選択したら、成功をとりましょう。

社会と経済の発展につれて、多くの人はIT技術を勉強します。なぜならば、IT職員にとって、Ciscoの642-997模擬対策資格証明書があるのは肝心な指標であると言えます。自分の能力を証明するために、642-997模擬対策試験に合格するのは不可欠なことです。弊社の642-997模擬対策真題を入手して、試験に合格する可能性が大きくなります。

642-997模擬対策 勉強資料は公式Ciscoの642-997模擬対策試験トレーニング授業 、Ciscoの642-997模擬対策 自習ガイド、Ciscoの642-997模擬対策 の試験と実践やCiscoの642-997模擬対策オンラインテストなどに含まれています。NewValidDumps がデザインしたCiscoの642-997模擬対策模擬トレーニングパッケージはあなたが楽に試験に合格することを助けます。

642-997 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 2
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 3
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 4
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 5
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

あなたにCisco　Microsoft DP-300J試験に関する最新かつ最完備の資料を勉強させ、試験に合格させることだと信じます。 Google Professional-Cloud-Architect - それに、あなたに美しい未来を作ることに助けを差し上げられます。 周りの多くの人は全部Cisco　HP HPE0-S59資格認定試験にパースしまして、彼らはどのようにできましたか。 SAP C-THR70-2404 - 現在の時代で高効率は避けられない話題ですから、速いスピードと高効率が我々の目標です。 そうすれば、あなたは簡単にSAP C-TS4CO-2023復習教材のデモを無料でダウンロードできます。

Updated: May 28, 2022