NewValidDumpsはもっぱらITプロ認証試験に関する知識を提供するのサイトで、ほかのサイト使った人はNewValidDumpsが最高の知識源サイトと比較しますた。NewValidDumpsの商品はとても頼もしい試験の練習問題と解答は非常に正確でございます。 NewValidDumpsの642-997最新テスト教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。試験問題集が更新されると、NewValidDumpsは直ちにあなたのメールボックスに642-997最新テスト問題集の最新版を送ります。 でも、NewValidDumpsは君の多くの貴重な時間とエネルギーを節約することを助けることができます。

642-997最新テスト認定試験の真実の問題に会うかもしれません。

CCNP Data Center 642-997最新テスト - Implementing Cisco Data Center Unified Fabric (DCUFI) 我々もオンライン版とソフト版を提供します。 ここで皆様に良い方法を教えてあげますよ。NewValidDumpsが提供したCiscoの642-997 資格認証攻略トレーニング資料を利用する方法です。

我々NewValidDumpsはCiscoの642-997最新テスト試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の642-997最新テスト試験問題集を開発するのに準備します。

それはNewValidDumpsのCisco 642-997最新テスト問題集です。

あなたより優れる人は存在している理由は彼らはあなたの遊び時間を効率的に使用できることです。どのようにすばらしい人になれますか？ここで、あなたに我々のCisco　642-997最新テスト試験問題集をお勧めください。弊社NewValidDumpsの642-997最新テスト試験問題集を介して、速く試験に合格して642-997最新テスト試験資格認定書を受け入れる一方で、他の人が知らない知識を勉強して優れる人になることに近くなります。

一回だけでCiscoの642-997最新テスト試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。NewValidDumpsは君にとってベストな選択になります。

642-997 PDF DEMO:

QUESTION NO: 1
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 2
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 3
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
If vPC peer keepalives are used between vPC peers, which VRF is used by default?
A. management
B. default
C. The user must dedicate a VRF for keepalives.
D. system
Answer: A

我々NewValidDumps提供するNetwork Appliance NS0-014問題集を通して、試験に迅速的にパースする技をファンドできます。 NewValidDumpsのCiscoのCompTIA SK0-005試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 Amazon SAA-C03-JPN - 暇の時間を利用して勉強します。 Huawei H19-412_V1.0 - 我々の誠意を信じてください。 現在の社会で、CheckPoint 156-215.81.20試験に参加する人がますます多くなる傾向があります。

Updated: May 28, 2022