多くの人はこんなに良いの認証試験を通ることが難しくて合格率はかなり低いと思っています。ちっとも努力しないと合格することが本当に難しいです。Cisco 642-997日本語版問題集試験を通るのはかなり優れた専門知識が必要です。 一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。NewValidDumpsの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoの642-997日本語版問題集認定試験対策模擬テスト問題集が研究しました。 弊社の資料を使って、１００％に合格を保証いたします。

642-997日本語版問題集認定試験に合格することは難しいようですね。

このような受験生は642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)日本語版問題集認定試験で高い点数を取得して、自分の構成ファイルは市場の需要と互換性があるように充分な準備をするのは必要です。 一回だけでCiscoの642-997 科目対策試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。NewValidDumpsは君にとってベストな選択になります。

Ciscoの642-997日本語版問題集試験は挑戦がある認定試験です。現在、書籍の以外にインターネットは知識の宝庫として見られています。NewValidDumps で、あなたにあなたの宝庫を見つけられます。

Cisco 642-997日本語版問題集 - あなたもIT認証資格を取りたいですか。

世の中に去年の自分より今年の自分が優れていないのは立派な恥です。それで、IT人材として毎日自分を充実して、642-997日本語版問題集問題集を学ぶ必要があります。弊社の642-997日本語版問題集問題集はあなたにこのチャンスを全面的に与えられます。あなたは自分の望ましいCisco 642-997日本語版問題集問題集を選らんで、学びから更なる成長を求められます。心はもはや空しくなく、生活を美しくなります。

試験問題集が更新されると、NewValidDumpsは直ちにあなたのメールボックスに642-997日本語版問題集問題集の最新版を送ります。あなたは試験の最新バージョンを提供することを要求することもできます。

642-997 PDF DEMO:

QUESTION NO: 1
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 2
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 3
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 4
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 5
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

また、Fortinet NSE7_NST-7.2問題集に疑問があると、メールで問い合わせてください。 NewValidDumpsはIT認定試験のFortinet NSE7_SDW-7.2-JPN問題集を提供して皆さんを助けるウエブサイトです。 人によって目標が違いますが、あなたにCisco　Cisco 100-490J試験に順調に合格できるのは我々の共同の目標です。 うちのCiscoのHuawei H20-421_V1.0学習教材はNewValidDumpsのIT専門家たちが研究して、実践して開発されたものです。 あなたに高品質で、全面的なIBM C1000-184参考資料を提供することは私たちの責任です。

Updated: May 28, 2022