我々の目的はあなたにCiscoの642-997日本語版参考資料試験に合格することだけです。試験に失敗したら、弊社は全額で返金します。我々の誠意を信じてください。 すべては豊富な内容があって各自のメリットを持っています。あなたは各バーションのCiscoの642-997日本語版参考資料試験の資料をダウンロードしてみることができ、あなたに一番ふさわしいバーションを見つけることができます。 Ciscoの642-997日本語版参考資料試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoの642-997日本語版参考資料試験に合格することができます。

642-997日本語版参考資料試験参考書は定期的に更新されますからです。

CCNP Data Center 642-997日本語版参考資料 - Implementing Cisco Data Center Unified Fabric (DCUFI) 弊社の商品が好きなのは弊社のたのしいです。 NewValidDumpsにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 642-997 試験内容認証試験に参加する方に対して問題集を研究続けています。

NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。

Cisco 642-997日本語版参考資料 - NewValidDumpsを選んだら、成功への扉を開きます。

NewValidDumpsが提供したCiscoの642-997日本語版参考資料トレーニング資料はあなたが自分の夢を実現することを助けられます。 NewValidDumpsはすべてのCiscoの642-997日本語版参考資料試験に受かるための資料に含まれていますから。NewValidDumpsを手にすると、あなたは安心に試験の準備に身を投げられるようになります。NewValidDumpsは高品質なトレーニング資料を提供して、あなたが試験に合格することを保証します。明るい未来を準備してあげます。

NewValidDumpsはあなたが試験に合格するのを助けることができるだけでなく、あなたは最新の知識を学ぶのを助けることもできます。このような素晴らしい資料をぜひ見逃さないでください。

642-997 PDF DEMO:

QUESTION NO: 1
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 2
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 3
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 4
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 5
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

NewValidDumpsというサイトは素晴らしいソースサイトで、CiscoのWGU Managing-Human-Capitalの試験材料、研究材料、技術材料や詳しい解答に含まれています。 NewValidDumpsのCisco 300-510問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。 Databricks Databricks-Certified-Professional-Data-Engineer - NewValidDumpsはIT職員としてのあなたに昇進するチャンスを与えられます。 NewValidDumpsのITエリートたちは彼らの専門的な目で、最新的なCiscoのSAP C_ABAPD_2309試験トレーニング資料に注目していて、うちのCiscoのSAP C_ABAPD_2309問題集の高い正確性を保証するのです。 NewValidDumpsのCiscoのAmazon SAA-C03-JPN試験トレーニング資料はIT認証試験を受ける人々の必需品です。

Updated: May 28, 2022