NewValidDumpsのCisco　642-997復習過去問問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。我々642-997復習過去問問題集の通過率は高いので、90％の合格率を保証します。あなたは弊社の高品質Cisco　642-997復習過去問試験資料を利用して、一回に試験に合格します。 それで、速く我々NewValidDumpsのCisco　642-997復習過去問試験問題集を入手しましょう。社会に入った後の私達は最もの責任があって、学習の時間は少なくなりました。 暇の時間を利用して勉強します。

CCNP Data Center 642-997 NewValidDumpsを選られば、成功しましょう。

CCNP Data Center 642-997復習過去問 - Implementing Cisco Data Center Unified Fabric (DCUFI) この試験に合格すれば君の専門知識がとても強いを証明し得ます。 弊社のIT業で経験豊富な専門家たちが正確で、合理的なCisco 642-997 全真模擬試験認証問題集を作り上げました。 弊社の勉強の商品を選んで、多くの時間とエネルギーを節約こともできます。

きみはCiscoの642-997復習過去問認定テストに合格するためにたくさんのルートを選択肢があります。NewValidDumpsは君のために良い訓練ツールを提供し、君のCisco認証試に高品質の参考資料を提供しいたします。あなたの全部な需要を満たすためにいつも頑張ります。

Cisco 642-997復習過去問 - きっと君に失望させないと信じています。

今あなたが無料でNewValidDumpsが提供したCiscoの642-997復習過去問認定試験の学習ガイドをダウンロードできます。それは受験者にとって重要な情報です。

我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。NewValidDumps Ciscoの642-997復習過去問試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。

642-997 PDF DEMO:

QUESTION NO: 1
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 2
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 3
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

WGU Organizational-Behaviors-and-Leadership - NewValidDumpsはきみのIT夢に向かって力になりますよ。 NewValidDumpsのCiscoのIIBA ECBAトレーニング資料即ち問題と解答をダウンロードする限り、気楽に試験に受かることができるようになります。 NewValidDumpsを利用したら、CiscoのSAP C_S4CS_2402試験に合格するのを心配することはないです。 IIBA ECBA - NewValidDumpsはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。 Cisco 100-490 - NewValidDumpsはそれを通じていつまでも最高の品質を持っています。

Updated: May 28, 2022