642-997専門知識訓練 資格取得

しかも、この試験を通して、あなたも自分の技能を高めて、仕事に役に立つスキルを多くマスターすることができます。そうすれば、あなたはもっと素敵に自分の仕事をやることができ、あなたの優れた能力を他の人に見せることができます。この方法だけであなたはより多くの機会を得ることができます。 どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。ITの専門者はCiscoの642-997専門知識訓練認定試験があなたの願望を助けって実現できるのがよく分かります。 一年以内に、あなたが持っている資料を更新したい限り、NewValidDumpsは最新バージョンの642-997専門知識訓練問題集を捧げます。

CCNP Data Center 642-997 弊社の商品が好きなのは弊社のたのしいです。

CCNP Data Center 642-997専門知識訓練 - Implementing Cisco Data Center Unified Fabric (DCUFI) NewValidDumpsを選択したら、成功が遠くではありません。 NewValidDumps を選択して100%の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。

あなたに予想外の良い効果を見せられますから。642-997専門知識訓練認定試験についてのことですが、NewValidDumpsは素晴らしい資質を持っていて、最も信頼できるソースになることができます。何千何万の登録された部門のフィードバックによって、それに大量な突っ込んだ分析を通じて、我々はどのサプライヤーがお客様にもっと新しいかつ高品質の642-997専門知識訓練資料を提供できるかを確かめる存在です。

Cisco 642-997専門知識訓練 - NewValidDumpsを選んだら、成功への扉を開きます。

642-997専門知識訓練認定試験の準備をするために一生懸命勉強して疲れを感じるときには、他の人が何をしているかを知っていますか。あなたと同じIT認定試験を受験する周りの人を見てください。あなたが試験のために不安と感じているとき、どうして他の人が自信満々で、のんびり見ているのでしょうか。あなたの能力は彼らうより弱いですか。もちろんそんなことはないです。では、なぜ他の人が簡単に642-997専門知識訓練試験に合格することができるかを知りたいですか。それは彼らがNewValidDumps の642-997専門知識訓練問題集を利用したからです。この問題集を勉強することだけで楽に試験に合格することができます。信じないのですか。不思議を思っていますか。では、急いで試してください。まず問題集のdemoを体験することができます。そうすれば、この問題集の品質を確認することができます。はやくNewValidDumpsのサイトをクリックしてください。

問題が更新される限り、NewValidDumpsは直ちに最新版の642-997専門知識訓練資料を送ってあげます。そうすると、あなたがいつでも最新バージョンの資料を持っていることが保証されます。

642-997 PDF DEMO:

QUESTION NO: 1
Which statement about the Layer 3 card on the Cisco Nexus 5500 Series Switch is true?
A. BGP support is not provided, but RIP, EIGRP, and OSPF support is provided.
B. Up to two 4-port cards are supported with up to 160 Gb/s of Layer 3 forwarding capability.
C. Up to 16 FEX connections are supported.
D. Port channels cannot be configured as Layer 3 interfaces.
Answer: C
Explanation:
From the Cisco NX-OS 5.1(3)N1(1) release and later releases, each Cisco Nexus 5500 Series device can manage and support up to 24 FEXs without Layer 3.
With Layer 3, the number of FEXs supported per Cisco Nexus 5500 Series device is 8. With Enhanced vPC and a dual-homed FEX topology each FEX is managed by both Cisco Nexus 5000 Series devices.
As a result, one pair of Cisco Nexus 5500 Series devices can support up to 24 FEXs and 16 FEXs for
Layer 2 and Layer 3.
Reference:
http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/mkt_ops_guides/513_n1_1/ n5k_enhanced_vpc.html

QUESTION NO: 2
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

QUESTION NO: 3
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 4
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 5
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

Microsoft DP-203J - もし試験に準備するときに良いツールを使えば、多くの時間を節約することができるだけでなく、楽に試験に合格する保障を手にすることもできます。 あるいは、無料で試験Microsoft DP-300問題集を更新してあげるのを選択することもできます。 SAP C-S4CPR-2402 - 学習教材がどんな問題があっても、あるいは君の試験を失敗したら、私たちは全額返金するのを保証いたします。 Cisco 300-630 - なぜ受験生のほとんどはNewValidDumpsを選んだのですか。 NewValidDumpsは君の早くCiscoのMicrosoft MB-240認定試験に合格するために、きみのもっと輝い未来のために、君の他人に羨ましいほど給料のために、ずっと努力しています。

Updated: May 28, 2022

642-997専門知識訓練、642-997無料過去問 - Cisco 642-997必殺問題集

PDF問題と解答

試験コード:642-997
試験名称:Implementing Cisco Data Center Unified Fabric (DCUFI)
最近更新時間:2024-06-15
問題と解答:全 152
Cisco 642-997 過去問無料

  ダウンロード


 

模擬試験

試験コード:642-997
試験名称:Implementing Cisco Data Center Unified Fabric (DCUFI)
最近更新時間:2024-06-15
問題と解答:全 152
Cisco 642-997 模擬試験サンプル

  ダウンロード


 

オンライン版

試験コード:642-997
試験名称:Implementing Cisco Data Center Unified Fabric (DCUFI)
最近更新時間:2024-06-15
問題と解答:全 152
Cisco 642-997 試験時間

  ダウンロード


 

642-997 最新受験攻略