NewValidDumpsの642-887模擬問題問題集の合格率が100%に達することも数え切れない受験生に証明された事実です。もし試験の準備をするために大変を感じているとしたら、ぜひNewValidDumpsの642-887模擬問題問題集を見逃さないでください。これは試験の準備をするために非常に効率的なツールですから。 未来のある日、椅子で休むとき、自分の人生を思い出したときに笑顔が出たら成功な人生になります。あなたは成功な人生がほしいですか。 あなたを試験に一発合格させる素晴らしい642-887模擬問題試験に関連する参考書が登場しますよ。

CCNP Service Provider 642-887 この問題集をミスすればあなたの大きな損失ですよ。

CCNP Service Provider 642-887模擬問題 - Implementing Cisco Service Provider Next-Generation Core Network Services もし不合格になったら、私たちは全額返金することを保証します。 この問題集は絶対あなたがずっと探しているものです。これは受験生の皆さんのために特別に作成し出された試験参考書です。

うちのCiscoの642-887模擬問題試験トレーニング資料を購入する前に、NewValidDumpsのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。君がうちの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。NewValidDumpsのCiscoの642-887模擬問題試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。

Cisco 642-887模擬問題 - 我々の誠意を信じてください。

NewValidDumpsはきっとご存じしています。それは現在、市場上でCisco の642-887模擬問題認定試験に合格する率が一番高いからです。あなたはうちのCiscoの642-887模擬問題問題集を購入する前に、一部分のフリーな試験問題と解答をダンロードして、試用してみることができます。ご利用によってで、うちのCiscoの642-887模擬問題問題集は正確性が高いです。Ciscoの642-887模擬問題問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。

自分のIT業界での発展を希望したら、Ciscoの642-887模擬問題試験に合格する必要があります。Ciscoの642-887模擬問題試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoの642-887模擬問題試験に合格することができます。

642-887 PDF DEMO:

QUESTION NO: 1
Scenario:
On CE 7 router, which statement is correct regarding the "QOS-POLICY policy map configurations?
A. The "QOS-POLICY is applied to the gi0/0 interface in the input direction
B. Traffic matched bythe"QOS-HTTP-1" class-map is shaped to an average is rate of 2560000
128000bps
C. Traffic matched bythe"QOS1-HTTP-2" class-map will be queued in the low-latency-queue which has a maximum bandwidth guarantee of 64000
D. Traffic matched by the "QOS-FTP-1" class-map can't use more than 256 Kbps under any condition
Answer: D
Explanation
# show policy-map
# show policy-map interface x/y
# show running-config policy-map

QUESTION NO: 2
Which three conditions can occur when metering traffic using a dual token bucket traffic policing QoS mechanism on Cisco routers? (Choose three.)
A. pass
B. burst
C. matched
D. exceed
E. violate
F. conform
Answer: D,E,F

QUESTION NO: 3
When using the tunnel mpls traffic-eng path-option 1 explicit name test command in Cisco
MPLS TE tunnel configurations, the test explicit-path configuration will consist of a list of which values?
A. resource class affinity
B. IP address
C. MPLS label
D. tunnel endpoint
Answer: B
Explanation
tunnel mpls traffic-eng path-option
To configure a path option for a Multiprotocol Label Switching (MPLS) traffic engineering tunnel, use the tunnel mpls traffic-eng path-option command in interface configuration mode. To disable the specified path option, use the no form of this command.
tunnel mpls traffic-eng path-option number {dynamic | explicit {name path-name | path-number}}
[lockdown] no tunnel mpls traffic-eng path-option number {dynamic | explicit {name path-name
| path-number}} [lockdown]
Syntax Description
number = When multiple path options are configured, lower numbered options are preferred.
dynamic = Path of the LSP is dynamically calculated.
explicit = Path of the LSP is an IP explicit path.
name path-name = Path name of the IP explicit path that the tunnel uses with this option.
path-number = Path number of the IP explicit path that the tunnel uses with this option.
lockdown = (Optional) The LSP cannot be reoptimized.
Usage Guidelines
You can configure multiple path options for a single tunnel. For example, there can be several explicit path options and a dynamic option for one tunnel. Path setup preference is for lower (not higher) numbers, so option 1 is preferred.
Examples
The following example shows how to configure the tunnel to use a named IP explicit path:
Router(config-if)# tunnel mpls traffic-eng path-option 1 explicit name test

QUESTION NO: 4
The Cisco IOS and IOS XE qos pre-classify command allows which kind of packet classification on IP packets that are encapsulated with GRE and IPsec?
A. allows for packets to be classified based on the packet payload before packet encryption
B. allows for packets to be classified based on the ToS byte values after packet encryption
C. allows for packets to be classified based on the packet payload after packet encryption
D. allows for packets to be classified based on the packet header parameters other than the ToS byte values after packet encryption
E. allows for packets to be classified based on the ToS byte values before packet encryption
Answer: E
Explanation
http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a008017405e.shtml
The qos pre-classify command When packets are encapsulated by tunnel or encryption headers, QoS features are unable to examine the original packet headers and correctly classify the packets. Packets traveling across the same tunnel have the same tunnel headers, so the packets are treated identically if the physical interface is congested. With the introduction of the Quality of Service for Virtual
Private Networks (VPNs) feature, packets can now be classified before tunneling and encryption occur.
In this example, tunnel0 is the tunnel name. The qos pre-classify command enables the QoS for VPNs feature on tunnel0:
Router(config)# interface tunnel0
Router(config-if)# qos pre-classify

QUESTION NO: 5
Which four pieces of information are stored for each prefix in the LFIB? (Choose four.)
A. incoming interface
B. next-hop IP address
C. outgoing interface
D. Layer 2 header rewrite information
E. outgoing label
F. local label
Answer: B,C,E,F
Explanation
Forwarding Labeled Packets
LSR forwards the packet based on:
Top Label value of the received packet
Corresponding entry in LFIB (LABEL <=> INTERFACE)
#show mpls forwarding-table - will show:
local label
outgoing label
prefix (network)
outgoing interface
next-hop
LSR expects packet to come with "top" label being "Local" (from show mpls forwarding-table).
If Outgoing label is "Aggregate", then that means that this is a summary route and more specific lookup is performed.
If LSR cannot find label/interface mapping in LFIB, then it drops the packet.
There are several "RESERVED" labels numbered from 0 to 15:
0 - explicit NULL - is used to preserver QoS info through EXP bits. It copies 'ip prec' or DiffServ.
1 - Router alert label - forces LSR to software switch the packet.
3 - Implicit NULL - this label is used for "connected" or "summary" routes. This way LSR signals it s neighbors to execute "POP label" operation on "connected" routes. It is called PHP, Penultimate
Hop Popping, and is used to make sure that LSR does not perform 2 lookups (label + ip).
14 - OEM alert label - is used for monitoring purpose.
In Cisco IOS, the default range is 16 through 100,000, but can be expanded by using "mpls label range" command.

Salesforce Salesforce-AI-Associate-JPN - あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。 弊社のOracle 1z0-071問題集はあなたにこのチャンスを全面的に与えられます。 SAP C_HAMOD_2404 - 我々のデモから感じられます。 短時間でIBM S2000-022試験に一発合格したいなら、我々社のCiscoのIBM S2000-022資料を参考しましょう。 CiscoのSAP C_DBADM_2404試験にリラクスで合格するのも可能性があります。

Updated: May 28, 2022