最近、Cisco　350-401関連合格問題試験に合格するのは重要な課題になっています。同時に、350-401関連合格問題資格認証を受け入れるのは傾向になります。350-401関連合格問題試験に参加したい、我々NewValidDumpsの350-401関連合格問題練習問題を参考しましょう。 IT認定試験の中でどんな試験を受けても、NewValidDumpsの350-401関連合格問題試験参考資料はあなたに大きなヘルプを与えることができます。それは NewValidDumpsの350-401関連合格問題問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。 誠意をみなぎるCisco　350-401関連合格問題試験備考資料は我々チームの専業化を展示されるし、最完全の質問と再詳細の解説でもって試験に合格するのを助けるます。

その中で、350-401関連合格問題認定試験は最も重要な一つです。

CCNP Enterprise 350-401関連合格問題 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) また、弊社はいいサービスを提供します。 NewValidDumpsのCiscoの350-401 参考書試験トレーニング資料を使ったら、君のCiscoの350-401 参考書認定試験に合格するという夢が叶えます。なぜなら、それはCiscoの350-401 参考書認定試験に関する必要なものを含まれるからです。

だから、あなたはコンピューターでCiscoのウエブサイトを訪問してください。そうすれば、あなたは簡単に350-401関連合格問題復習教材のデモを無料でダウンロードできます。そして、あなたは350-401関連合格問題復習教材の三種類のデモをダウンロードできます。

Cisco 350-401関連合格問題 - それは正確性が高くて、カバー率も広いです。

ここで無料にNewValidDumpsが提供したCiscoの350-401関連合格問題試験の部分練習問題と解答をダウンロードできて、一度NewValidDumpsを選ばれば、弊社は全力に貴方達の合格を頑張ります。貴方達の試験に合格させることができないと、すぐに全額で返金いたします。

もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoの350-401関連合格問題試験のソフトウェアです。我々はあなたに提供するのは最新で一番全面的なCiscoの350-401関連合格問題問題集で、最も安全な購入保障で、最もタイムリーなCiscoの350-401関連合格問題試験のソフトウェアの更新です。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

Amazon SOA-C02 - たくさんのひとは弊社の商品を使って、試験に順調に合格しました。 CiscoのCIPS L3M4の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoのCIPS L3M4試験に一番信頼できるヘルプを提供します。 今の人材が多い社会中に多くの業界は人材不足でたとえばIT業界はかなり技術的な人材が不足で、CiscoのMicrosoft MD-102認定試験はIT技術の認証試験の1つで、NewValidDumpsはCiscoのMicrosoft MD-102認証試験に関するの特別な技術を持ってサイトでございます。 Snowflake SnowPro-Core-JPN - 社会と経済の発展につれて、多くの人はIT技術を勉強します。 Salesforce Advanced-Administrator-JPN - 真実試験問題が似てるのを確保することができて一回合格するのは目標にしています。

Updated: May 28, 2022