我々NewValidDumpsはCiscoの350-401試験勉強攻略試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401試験勉強攻略試験問題集を開発するのに準備します。 350-401試験勉強攻略試験のために、気楽に準備したり、参加したりしています。その他、我々の350-401試験勉強攻略日本語問題集を購入すると、英語版を送ります。 ほんとんどお客様は我々NewValidDumpsのCisco　350-401試験勉強攻略問題集を使用してから試験にうまく合格しましたのは弊社の試験資料の有効性と信頼性を説明できます。

350-401試験勉強攻略問題集を利用して試験に合格できます。

CCNP Enterprise 350-401試験勉強攻略 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 試験にパースする原因は我々問題集の全面的で最新版です。 NewValidDumpsにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が１００％にまで達します。弊社のみたいなウエブサイトが多くても、彼たちは君の学習についてガイドやオンラインサービスを提供するかもしれないが、弊社はそちらにより勝ちます。

我々社のCisco　350-401試験勉強攻略認定試験問題集の合格率は高いのでほとんどの受験生は350-401試験勉強攻略認定試験に合格するのを保証します。もしあなたはCisco　350-401試験勉強攻略試験問題集に十分な注意を払って、350-401試験勉強攻略試験の解答を覚えていれば、350-401試験勉強攻略認定試験の成功は明らかになりました。Cisco　350-401試験勉強攻略模擬問題集で実際の質問と正確の解答に疑問があれば、無料の練習問題集サンプルをダウンロードし、チェックしてください。

Cisco 350-401試験勉強攻略 - 近年、IT領域で競争がますます激しくなります。

われわれは今の競争の激しいIT社会ではくつかIT関連認定証明書が必要だとよくわかります。IT専門知識をテストしているCiscoの350-401試験勉強攻略認定試験は1つのとても重要な認証試験でございます。しかしこの試験は難しさがあって、合格率がずっと低いです。でもNewValidDumpsの最新問題集がこの問題を解決できますよ。350-401試験勉強攻略認定試験の真実問題と模擬練習問題があって、十分に試験に合格させることができます。

NewValidDumpsのCiscoの350-401試験勉強攻略試験トレーニング資料は豊富な知識と経験を持っているIT専門家に研究された成果で、正確度がとても高いです。NewValidDumpsに会ったら、最高のトレーニング資料を見つけました。

350-401 PDF DEMO:

QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

Salesforce Salesforce-AI-Specialist - NewValidDumpsが開発された試験の問題と解答は異なるターゲットに含まれていますし、カバー率が高いですから、それを超える書籍や資料が絶対ありません。 CompTIA 220-1101 - これは試験の準備をするために非常に効率的なツールですから。 Salesforce CRT-450-JPN - 我々はIT領域の人々にショートカットを提供するために、最高のスタディガイドと最高のオンラインサービスを用意して差し上げます。 いまCisco 300-445試験に合格するショートカットを教えてあげますから。 このような受験生はCompTIA DA0-001J認定試験で高い点数を取得して、自分の構成ファイルは市場の需要と互換性があるように充分な準備をするのは必要です。

Updated: May 28, 2022