Ciscoの350-401模擬問題の認定試験証明書を取りたいなら、NewValidDumpsが貴方達を提供した資料をかったら、お得です。NewValidDumpsはもっぱら認定試験に参加するIT業界の専門の人士になりたい方のために模擬試験の練習問題と解答を提供した評判の高いサイトでございます。 なぜ受験生のほとんどはNewValidDumpsを選んだのですか。それはNewValidDumpsがすごく便利で、広い通用性があるからです。 給料もほかの人と比べて高くて仕事の内容も豊富です。

CCNP Enterprise 350-401 しかも値段が手頃です。

そして、350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模擬問題試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。 この試験に受かるのは難しいですが、大丈夫です。私はNewValidDumpsのCiscoの350-401 最新対策問題試験トレーニング資料を選びましたから。

Ciscoの350-401模擬問題の認定試験に合格すれば、就職機会が多くなります。この試験に合格すれば君の専門知識がとても強いを証明し得ます。Ciscoの350-401模擬問題の認定試験は君の実力を考察するテストでございます。

Cisco 350-401模擬問題 - きっと君に失望させないと信じています。

最近、NewValidDumpsはIT認定試験に属するいろいろな試験に関連する最新版の350-401模擬問題問題集を提供し始めました。例えば350-401模擬問題日本語問題集などいろいろあります。これらの試験問題集は最新の350-401模擬問題試験のシラバスに従って作成されたものです。試験について最新の情報を伝えられます。試験のシラバスがどのような変更をしたのか、試験に出る可能性がある新しい種類の問題について、これらの最新版の問題集には全部含まれています。ですから、IT認証試験を受験したいなら、NewValidDumpsの350-401模擬問題問題集を利用したほうがいいです。なぜなら、これはあなたがよりよく試験の準備をすることができる最高の方法ですから。

我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。NewValidDumps Ciscoの350-401模擬問題試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

Salesforce Public-Sector-Solutions - NewValidDumpsの学習教材はいろいろな狙いを含まれていますし、カバー率が高いですから、初心者にしても簡単に身に付けられます。 NewValidDumpsのCiscoのScrum PSPO-Iトレーニング資料即ち問題と解答をダウンロードする限り、気楽に試験に受かることができるようになります。 激変なネット情報時代で、質の良いCiscoのMicrosoft PL-200問題集を見つけるために、あなたは悩むことがありませんか。 Fortinet NSE7_PBC-7.2 - NewValidDumpsはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。 ご心配なく、NewValidDumpsのCiscoのPegasystems PEGACPLSA23V1試験トレーニング資料を手に入れるなら、ITに関する認定試験はなんでも楽に合格できます。

Updated: May 28, 2022