NewValidDumpsのCiscoの350-401模擬トレーリング試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。君がCiscoの350-401模擬トレーリング問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの350-401模擬トレーリング問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。 これはNewValidDumpsのCiscoの350-401模擬トレーリング試験トレーニング資料は確かに信頼できて、受験生の皆様が首尾よく試験に合格することに助けを差し上げられることが証明されました。NewValidDumpsのCiscoの350-401模擬トレーリング試験トレーニング資料がベストセラーになって、他のサイトをずっと先んじて皆様の認可を取りましたから、好評は言うまでもないです。 弊社のNewValidDumpsはIT認定試験のソフトの一番信頼たるバンドになるという目標を達成するために、弊社はあなたに最新版のCiscoの350-401模擬トレーリング試験問題集を提供いたします。

CCNP Enterprise 350-401 試験に失敗したら、全額で返金する承諾があります。

NewValidDumpsのCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模擬トレーリング試験トレーニング資料を利用したら、望むことを取得できます。 あなたは各バーションのCiscoの350-401 ウェブトレーニング試験の資料をダウンロードしてみることができ、あなたに一番ふさわしいバーションを見つけることができます。暇な時間だけでCiscoの350-401 ウェブトレーニング試験に合格したいのですか。

NewValidDumps は世界的によく知られているサイトです。どうしてこのような大きな連鎖反応になりましたか。それはNewValidDumpsのCiscoの350-401模擬トレーリング試験トレーニング資料は適用性が高いもので、本当にみなさんが良い成績を取ることを助けられるからです。

Cisco 350-401模擬トレーリング - しかも、楽に試験に合格することができます。

Ciscoの350-401模擬トレーリング試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でNewValidDumpsは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。

もし学習教材は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。NewValidDumpsのCiscoの350-401模擬トレーリング試験トレーニング資料は正確性が高くて、カバー率も広い。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

VMware 2V0-41.23 - どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。 NewValidDumpsのCiscoのSalesforce Marketing-Cloud-Email-Specialist-JPN試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。 Fortinet NSE5_FAZ-7.2 - 一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。 IBM S2000-022 - あなたに提供するソフトはその中の一部です。 SAP C_SIGDA_2403 - あなたに向いていることを確かめてから買うのも遅くないですよ。

Updated: May 28, 2022