当然、購入した後、あなたはどんな疑問があると、次々に丁寧に返答できます。あなたの送信を歓迎しております。あなたに行き届いたサービスを提供できるのは我々の幸いです。 きっと君に失望させないと信じています。最新Ciscoの350-401日本語試験情報認定試験は真実の試験問題にもっとも近くて比較的に全面的でございます。 我々はあなたにCisco　350-401日本語試験情報試験に合格させるために、全力を尽くします。

350-401日本語試験情報練習資料が最も全面的な参考書です。

CCNP Enterprise 350-401日本語試験情報 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) NewValidDumpsはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。 弊社が提供した部分の資料を試用してから、決断を下ろしてください。もし弊社を選ばれば、１００％の合格率を保証でございます。

また、NewValidDumpsのCiscoの350-401日本語試験情報試験トレーニング資料が信頼できるのは多くの受験生に証明されたものです。NewValidDumpsのCiscoの350-401日本語試験情報試験トレーニング資料を利用したらきっと成功できますから、NewValidDumpsを選ばない理由はないです。試験の準備をするためにNewValidDumpsのCiscoの350-401日本語試験情報試験トレーニング資料を買うのは冒険的行為と思ったとしたら、あなたの人生の全てが冒険なことになります。

Cisco 350-401日本語試験情報 - 早くNewValidDumpsの問題集を君の手に入れましょう。

NewValidDumpsのCiscoの350-401日本語試験情報試験トレーニング資料を使ったら、君のCiscoの350-401日本語試験情報認定試験に合格するという夢が叶えます。なぜなら、それはCiscoの350-401日本語試験情報認定試験に関する必要なものを含まれるからです。NewValidDumpsを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。まだ何を待っていますか。早速買いに行きましょう。

でも多くの人が合格するために大量の時間とエネルギーをかかって、無駄になります。同等の効果は、NewValidDumpsは君の貴重な時間とお金を節約するだけでなく１００％の合格率を保証いたします。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

Microsoft SC-400J - それは正確性が高くて、カバー率も広いです。 The Open Group OGEA-103 - NewValidDumpsは認証試験の専門的なリーダーで、最全面的な認証基準のトレーニング方法を追求して、１００パーセントの成功率を保証します。 無料デモはあなたに安心で購入して、購入した後1年間の無料CiscoのCWNP CWISA-102試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。 Cisco 350-501 - NewValidDumpsはIT領域の10年以上の認定経験を持っていますから、問題と解答に含まれています。 SAP C-TADM-23 - 我々の承諾だけでなく、お客様に最も全面的で最高のサービスを提供します。

Updated: May 28, 2022