NewValidDumpsのCiscoの350-401問題例試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。それはあなたがいつでも最新の試験資料を持てるということです。試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。 この素晴らしい問題集はNewValidDumpsによって提供されます。350-401問題例認定試験の準備を完了したのですか。 NewValidDumpsのCiscoの350-401問題例試験トレーニング資料は最高のトレーニング資料です。

CCNP Enterprise 350-401 あなたは体験してから安心で購入できます。

CCNP Enterprise 350-401問題例 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 常々、時間とお金ばかり効果がないです。 IT業界で発展したいなら、Ciscoの350-401 学習範囲試験のような国際的な試験に合格するのは重要です。我々NewValidDumpsはITエリートの皆さんの努力であなたにCiscoの350-401 学習範囲試験に速く合格する方法を提供します。

NewValidDumpsは多くの受験生を助けて彼らにCiscoの350-401問題例試験に合格させることができるのは我々専門的なチームがCiscoの350-401問題例試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの350-401問題例試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。

Cisco 350-401問題例 - 暇の時間を利用して勉強します。

350-401問題例問題集は唯一無にな参考資料です。350-401問題例問題集の内容は専門的かつ全面的で、覚えやすいです。また、350-401問題例問題集は的中率が高いです。そのいくつの点で、350-401問題例試験に合格することを保障できます。もし、お客様は350-401問題例問題集を買うとき、自分に適するかどうかという心配があります。その心配に対して、弊社はお客様に無料で350-401問題例問題集のデモを提供します。そうしたら、お客様は350-401問題例問題集を購入する前にデモをダウンロードしてやってみることができます。

そして、350-401問題例試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。350-401問題例試験参考書があれば,ほかの試験参考書を勉強する必要がないです。

350-401 PDF DEMO:

QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

Versa Networks VNX100 - NewValidDumpsを選られば、成功しましょう。 CiscoのSAP C_SIGDA_2403の認定試験に合格すれば、就職機会が多くなります。 SAP C_DBADM_2404 - 弊社の勉強の商品を選んで、多くの時間とエネルギーを節約こともできます。 UiPath UiPath-ABAv1 - あなたの全部な需要を満たすためにいつも頑張ります。 CiscoのSalesforce Industries-CPQ-Developer認定試験の合格証明書はあなたの仕事の上で更に一歩の昇進で生活条件が向上することが助けられます。

Updated: May 28, 2022