NewValidDumpsのCiscoの350-401合格体験記トレーニング資料即ち問題と解答をダウンロードする限り、気楽に試験に受かることができるようになります。まだ困っていたら、我々の試用版を使ってみてください。ためらわずに速くあなたのショッピングカートに入れてください。 NewValidDumpsは間違いなくあなたの利益を全面的に保護し、あなたの悩みを思いやるウェブサイトです。もうこれ以上尻込みしないでくださいよ。 NewValidDumpsはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。

Ciscoの350-401合格体験記試験の準備に悩んでいますか。

CCNP Enterprise 350-401合格体験記 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) NewValidDumpsを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。 もしあなたが試験に合格する決心があったら、我々のCiscoの350-401 受験練習参考書ソフトを利用するのはあなたの試験に成功する有効な保障です。我々のCiscoの350-401 受験練習参考書ソフトのデモをダウンロードしてみて我々NewValidDumpsのあなたに合格させる自信を感じられます。

NewValidDumpsのCiscoの350-401合格体験記試験トレーニング資料はCiscoの350-401合格体験記認定試験を準備するのリーダーです。NewValidDumpsの Ciscoの350-401合格体験記試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。それは正確性が高くて、カバー率も広いです。

Cisco 350-401合格体験記 - PDF版、ソフト版、オンライン版があります。

我々の承諾だけでなく、お客様に最も全面的で最高のサービスを提供します。Ciscoの350-401合格体験記の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoの350-401合格体験記試験に一番信頼できるヘルプを提供します。Ciscoの350-401合格体験記試験に失敗しても、我々はあなたの経済損失を減少するために全額で返金します。

キャンパース内のIT知識を学ぶ学生なり、IT職人なり、350-401合格体験記試験資格認証証明書を取得して、社会需要に応じて自分の能力を高めます。我々社は最高のCisco　350-401合格体験記試験問題集を開発し提供して、一番なさービスを与えて努力しています。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

自分の能力を証明するために、SAP C_HCMP_2311試験に合格するのは不可欠なことです。 安全かつ最も信頼性の高いCisco　SAP C-DBADM-2404問題集販売サイトとして、我々はお客様の個人情報を内緒し、支払いの安全性を保証しています。 Huawei H31-311_V2.5 - 我々NewValidDumpsは一番行き届いたアフタサービスを提供します。 実際の試験に表示される質問と正確な解答はあなたのCisco　Salesforce Salesforce-Sales-Representative認定資格試験合格を手伝ってあげます。 我々社サイトのCisco　Microsoft SC-100J問題庫は最新かつ最完備な勉強資料を有して、あなたに高品質のサービスを提供するのはMicrosoft SC-100J資格認定試験の成功にとって唯一の選択です。

Updated: May 28, 2022