NewValidDumpsはあなたが次のCiscoの350-401出題範囲認定試験に合格するように最も信頼できるトレーニングツールを提供します。NewValidDumpsのCiscoの350-401出題範囲勉強資料は問題と解答を含めています。それは実践の検査に合格したソフトですから、全ての関連するIT認証に満たすことができます。 認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoの350-401出題範囲試験を研究していますから、Ciscoの350-401出題範囲認定試験に受かりたかったら、NewValidDumpsのサイトをクッリクしてください。あなたに成功に近づいて、夢の楽園に一歩一歩進めさせられます。 当社の資料はあなたがIT専門家になるように特別に受験生の皆さんのために作成したものです。

CCNP Enterprise 350-401 NewValidDumpsを選んだら、成功への扉を開きます。

CCNP Enterprise 350-401出題範囲 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 職場でも同じです。 したがって、NewValidDumpsの350-401 関連問題資料問題集も絶えずに更新されています。それに、NewValidDumpsの教材を購入すれば、NewValidDumpsは一年間の無料アップデート・サービスを提供してあげます。

このサイトはIT認定試験を受けた受験生から広く好評されました。これはあなたに本当のヘルプを与えるサイトです。では、なぜNewValidDumpsは皆さんの信頼を得ることができますか。

Cisco 350-401出題範囲 - 自分の幸せは自分で作るものだと思われます。

なぜみんなが順調にCiscoの350-401出題範囲試験に合格できることに対する好奇心がありますか。Ciscoの350-401出題範囲試験に合格したいんですか。実は、彼らが試験に合格したコツは我々NewValidDumpsの提供するCiscoの350-401出題範囲試験ソフトを利用したんです。豊富の問題集、専門的な研究と購入の後の一年間の無料更新、ソフトで復習して、自分の能力の高めを感じられます。Ciscoの350-401出題範囲試験に合格することができます。

あなたは弊社の高品質Cisco　350-401出題範囲試験資料を利用して、一回に試験に合格します。NewValidDumpsのCisco　350-401出題範囲問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

しかし、我々NewValidDumpsチームは力を尽くしてあなたのCiscoのSalesforce Heroku-Architect試験を準備する圧力を減少して規範的な模擬問題と理解しやすい解答分析はあなたにCiscoのSalesforce Heroku-Architect試験に合格するコツを把握させます。 Huawei H19-412_V1.0 - IT職員のあなたは毎月毎月のあまり少ない給料を持っていますが、暇の時間でひたすら楽しむんでいいですか。 CiscoのSAP C-S4CS-2402試験は小さな試験だけでなく、あなたの職業生涯に重要な影響を及ぼすことができます。 多分、Microsoft AZ-800テスト質問の数が伝統的な問題の数倍である。 Salesforce Customer-Data-Platform - この時代にはIT資格認証を取得するは重要になります。

Updated: May 28, 2022