Ciscoの350-401クラムメディア試験のほかの認証試験も大切なのです。それに、これらの資料は我々NewValidDumpsのウェブサイトで見つけることができます。時には、進める小さなステップは人生の中での大きなステップとするかもしれません。 そして、350-401クラムメディア試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。350-401クラムメディア試験参考書があれば,ほかの試験参考書を勉強する必要がないです。 それでは、350-401クラムメディア試験に参加しよう人々は弊社NewValidDumpsの350-401クラムメディア問題集を選らんで勉強して、一発合格して、CiscoIT資格証明書を受け取れます。

CCNP Enterprise 350-401 きっと君に失望させないと信じています。

350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)クラムメディア試験参考書があれば,ほかの試験参考書を勉強する必要がないです。 我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。NewValidDumps Ciscoの350-401 必殺問題集試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。

あなた達はNewValidDumpsの商品を購入してもっともはやく正確に試験に関する情報を手に入れます。NewValidDumpsの商品は試験問題を広くカーバして、認証試験の受験生が便利を提供し、しかも正確率100%です。そして、試験を安心に参加してください。

Cisco 350-401クラムメディア - しかしその可能性はほとんどありません。

試験の準備をするためにNewValidDumpsのCiscoの350-401クラムメディア試験トレーニング資料を買うのは冒険的行為と思ったとしたら、あなたの人生の全てが冒険なことになります。一番遠いところへ行った人はリスクを背負うことを恐れない人です。また、NewValidDumpsのCiscoの350-401クラムメディア試験トレーニング資料が信頼できるのは多くの受験生に証明されたものです。NewValidDumpsのCiscoの350-401クラムメディア試験トレーニング資料を利用したらきっと成功できますから、NewValidDumpsを選ばない理由はないです。

この情報の時代には、IT業界にとても注目され、この強い情報技術業界にIT人材が得難いです。こうしてCisco認定試験がとても重要になります。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

それは NewValidDumpsのSAP C_S4CPR_2402問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。 CiscoのHP HP2-I69認証試験に関する訓練は対応性のテストで君を助けることができて、試験の前に十分の準備をさしあげます。 SAP C-S4CPR-2402 - Ciscoの認証資格は最近ますます人気になっていますね。 CIPS L3M4 - NewValidDumpsはいつまでもあなたのそばにいて、あなたと一緒に苦楽を共にするのです。 なぜなら、それはCiscoのTableau Desktop-Certified-Associate-JPN認定試験に関する必要なものを含まれるからです。

Updated: May 28, 2022