300-101復習資料 資格取得

だから、弊社の提供する300-101復習資料問題集を暗記すれば、きっと試験に合格できます。数年以来の整理と分析によって開発された300-101復習資料問題集は権威的で全面的です。300-101復習資料問題集を利用して試験に合格できます。 業界のリーダーとなっているために、我々は確かに独自のリソースを拡大し続ける必要があります。我々NewValidDumpsは常に試験問題集とソフトウェアの内容を更新します。 NewValidDumpsにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が100%にまで達します。

300-101復習資料問題集の特徴は便利で使い安いです。

現在、Ciscoの300-101 - Implementing Cisco IP Routing復習資料認定試験に受かりたいIT専門人員がたくさんいます。 おそらく、君たちは私たちの300-101 最速合格試験資料について何も知らないかもしれません。でも、私たちの300-101 最速合格試験資料のデモをダウンロードしてみると、全部わかるようになります。

NewValidDumpsは優れたIT情報のソースを提供するサイトです。NewValidDumpsで、あなたの試験のためのテクニックと勉強資料を見つけることができます。NewValidDumpsのCiscoの300-101復習資料試験トレーニング資料は豊富な知識と経験を持っているIT専門家に研究された成果で、正確度がとても高いです。

Cisco 300-101復習資料 - 君の夢は1歩更に近くなります。

300-101復習資料認定試験に合格することは難しいようですね。試験を申し込みたいあなたは、いまどうやって試験に準備すべきなのかで悩んでいますか。そうだったら、下記のものを読んでください。いま300-101復習資料試験に合格するショートカットを教えてあげますから。あなたを試験に一発合格させる素晴らしい300-101復習資料試験に関連する参考書が登場しますよ。それはNewValidDumpsの300-101復習資料問題集です。気楽に試験に合格したければ、はやく試しに来てください。

NewValidDumpsの助けのもとで君は大量のお金と時間を费やさなくても復楽にCiscoの300-101復習資料認定試験に合格のは大丈夫でしょう。ソフトの問題集はNewValidDumpsが実際問題によって、テストの問題と解答を分析して出来上がりました。

300-101 PDF DEMO:

QUESTION NO: 1
Which interface type does a PPPoE client use to establish a session?
A. Physical
B. Loopback
C. Virtual-template
D. Dialer
Answer: D
Explanation
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/bbdsl/configuration/xe-3s/bba-pppoe- client.html

QUESTION NO: 2
JS Industries has expanded their business with the addition of their first remote office. The remote office router (R3) was previously configured and all Corporate subnets were reachable from
R3. JS Industries is interested in using route summarization along with the EIGRP Stub Routing feature to increase network stability while reducing the memory usage and bandwidth utilization to R3.
Another network professional was tasked with implementing this solution. However, in the process of configuring EIGRP stub routing connectivity with the remote network devices off of R3 has been lost.
Currently EIGRP is configured on all routers R2, R3, and R4 in the network. Your task is to identify and resolve the cause of connectivity failure with the remote office router R3. Once the issue has been resolved you should complete the task by configuring route summarization only to the remote office router R3.
You have corrected the fault when pings from R2 to the R3 LAN interface are successful, and the R3 IP routing table only contains 2 10.0.0.0 subnets.
Answer:
See the Explanation below.
Explanation
First we have to figure out why R3 and R4 can not communicate with each other. Use the show running-config command on router R3.
[eigrp10.jpg]
Notice that R3 is configured as a stub receive-only router. The receive-only keyword will restrict the router from sharing any of its routes with any other router in that EIGRP autonomous system. This keyword will also prevent any type of route from being sent. Therefore we will remove this command and replace it with the eigrp stub command:
R3# configure terminal R3(config)# router eigrp 123 R3(config-router)# no eigrp stub receive-only
R3(config-router)# eigrp stub R3(config-router)# end Now R3 will send updates containing its connected and summary routes to other routers. Notice that the eigrp stub command equals to the eigrp stub connected summary because the connected and summary options are enabled by default.
Next we will configure router R3 so that it has only 2 subnets of 10.0.0.0 network. Use the show ip route command on R3 to view its routing table:
[ee1%255B5%255D.jpg]
Because we want the routing table of R3 only have 2 subnets so we have to summary sub-networks at the interface which is connected with R3, the s0/0 interface of R4.
There is one interesting thing about the output of the show ip route shown above: the 10.2.3.0/24, which is a directly connected network of R3. We can't get rid of it in the routing table no matter what technique we use to summary the networks. Therefore, to make the routing table of R3 has only 2 subnets we have to summary other subnets into one subnet.
In the output if we don't see the summary line (like 10.0.0.0/8 is a summary...) then we should use the command ip summary-address eigrp 123 10.2.0.0 255.255.0.0 so that all the ping can work well.
In conclusion, we will use the ip summary-address eigrp 123 10.2.0.0 255.255.0.0 at the interface s0/0 of R4 to summary.
R4> enable R4# conf t
R4(config)# interface s0/0 R4(config-if)# ip summary-address eigrp 123 10.2.0.0 255.255.0.0 Now we jump back to R3 and use the show ip route command to verify the effect, the output is shown below:
[ee2%255B5%255D.jpg]
Note: Please notice that the IP addresses and the subnet masks in your real exam might be different so you might use different ones to solve this question.
Just for your information, notice that if you use another network than 10.0.0.0/8 to summary, for example, if you use the command ip summary-address eigrp 123 10.2.0.0 255.255.0.0 you will leave a
/16 network in the output of the show ip route command.
[ee3%255B5%255D.jpg]
But in your real exam, if you don't see the line "10.0.0.0/8 is a summary, Null0" then you can summarize using the network 10.2.0.0/16. This summarization is better because all the pings can work well.
Finally don't forget to use the copy run start command on routers R3 and R4 to save the configurations.
R3(config-if)# end
R3# copy run start
R4(config-if)# end
R4# copy run start
If the "copy run start" command doesn't work then use "write memory".

QUESTION NO: 3
Which two types of threshold are configured for tracking objects? (Choose two.)
A. Percentage
B. Delay
C. Bandwidth
D. Administrative distance
E. Weight
Answer: A,E

QUESTION NO: 4
The OSPF database of a router shows LSA types 1.2,7, and a type 3 default route only. Which type of area is this router connected to?
A. NSSA
B. NSSA totally stub
C. tub area
D. totally stubby area
Answer: A

QUESTION NO: 5
Which condition prevents the establishment of a DMPVN tunnel between two spokes?
A. HSRP is enabled on the spoke devices
B. IPsec is enabled on the spoke devices
C. The two spokes are behind different PAT devices
D. The two spokes have different tunnel keepalive settings
Answer: D

Scrum PSPO-II - NewValidDumpsは君にとってベストな選択になります。 CompTIA 220-1102 - 。 うちのCiscoのSAP C-FIORD-2404試験トレーニング資料を購入する前に、NewValidDumpsのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。 Microsoft AZ-104J - 最新の資源と最新の動態が第一時間にお客様に知らせいたします。 我々の目的はあなたにCiscoのHuawei H21-421_V1.0試験に合格することだけです。

Updated: May 28, 2022

300-101復習資料 & Cisco Implementing Cisco IP Routing入門知識

PDF問題と解答

試験コード:300-101
試験名称:Implementing Cisco IP Routing
最近更新時間:2024-03-28
問題と解答:全 225
Cisco 300-101 合格内容

  ダウンロード


 

模擬試験

試験コード:300-101
試験名称:Implementing Cisco IP Routing
最近更新時間:2024-03-28
問題と解答:全 225
Cisco 300-101 受験記対策

  ダウンロード


 

オンライン版

試験コード:300-101
試験名称:Implementing Cisco IP Routing
最近更新時間:2024-03-28
問題と解答:全 225
Cisco 300-101 合格問題

  ダウンロード


 

300-101 英語版