NewValidDumpsはきみの貴重な時間を節約するだけでなく、 安心で順調に試験に合格するのを保証します。NewValidDumpsは専門のIT業界での評判が高くて、あなたがインターネットでNewValidDumpsの部分のCisco 300-101合格体験談「Implementing Cisco IP Routing」資料を無料でダウンロードして、弊社の正確率を確認してください。弊社の商品が好きなのは弊社のたのしいです。 NewValidDumps Ciscoの300-101合格体験談試験トレーニング資料は信頼できる製品です。当社のスタッフ は受験生の皆様が試験で高い点数を取ることを保証できるように、巨大な努力をして皆様に最新版の300-101合格体験談試験トレーニング資料を提供しています。 NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。

CCNP 300-101 早くNewValidDumpsの問題集を君の手に入れましょう。

早くNewValidDumpsのCiscoの300-101 - Implementing Cisco IP Routing合格体験談試験トレーニング資料を買いに行きましょう。 君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにNewValidDumpsを選択してください。NewValidDumpsはまた一年間に無料なサービスを更新いたします。

しかも、昇進と高給も実現できます。Ciscoの300-101合格体験談試験に受かったら成功への鍵を握ったと言った人もいます。これは間違いないです。

Cisco 300-101合格体験談 - NewValidDumpsには専門的なエリート団体があります。

NewValidDumpsの300-101合格体験談問題集はあなたの一発合格を保証できる資料です。問題集の的中率はとても高いですから、この問題集だけで試験に合格することができます。信じられなら利用してみてください。不合格になればNewValidDumpsは全額返金のことができますから、絶対損にならないです。利用したら300-101合格体験談問題集の品質がわかるようになるので、まず問題集の無料なサンプルを試しましょう。問題集のdemoが無料で提供されますから、NewValidDumpsのサイトをクリックしてダウンロードしてください。

NewValidDumpsのCiscoの300-101合格体験談試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。それはあなたがいつでも最新の試験資料を持てるということです。

300-101 PDF DEMO:

QUESTION NO: 1
JS Industries has expanded their business with the addition of their first remote office. The remote office router (R3) was previously configured and all Corporate subnets were reachable from
R3. JS Industries is interested in using route summarization along with the EIGRP Stub Routing feature to increase network stability while reducing the memory usage and bandwidth utilization to R3.
Another network professional was tasked with implementing this solution. However, in the process of configuring EIGRP stub routing connectivity with the remote network devices off of R3 has been lost.
Currently EIGRP is configured on all routers R2, R3, and R4 in the network. Your task is to identify and resolve the cause of connectivity failure with the remote office router R3. Once the issue has been resolved you should complete the task by configuring route summarization only to the remote office router R3.
You have corrected the fault when pings from R2 to the R3 LAN interface are successful, and the R3 IP routing table only contains 2 10.0.0.0 subnets.
Answer:
See the Explanation below.
Explanation
First we have to figure out why R3 and R4 can not communicate with each other. Use the show running-config command on router R3.
[eigrp10.jpg]
Notice that R3 is configured as a stub receive-only router. The receive-only keyword will restrict the router from sharing any of its routes with any other router in that EIGRP autonomous system. This keyword will also prevent any type of route from being sent. Therefore we will remove this command and replace it with the eigrp stub command:
R3# configure terminal R3(config)# router eigrp 123 R3(config-router)# no eigrp stub receive-only
R3(config-router)# eigrp stub R3(config-router)# end Now R3 will send updates containing its connected and summary routes to other routers. Notice that the eigrp stub command equals to the eigrp stub connected summary because the connected and summary options are enabled by default.
Next we will configure router R3 so that it has only 2 subnets of 10.0.0.0 network. Use the show ip route command on R3 to view its routing table:
[ee1%255B5%255D.jpg]
Because we want the routing table of R3 only have 2 subnets so we have to summary sub-networks at the interface which is connected with R3, the s0/0 interface of R4.
There is one interesting thing about the output of the show ip route shown above: the 10.2.3.0/24, which is a directly connected network of R3. We can't get rid of it in the routing table no matter what technique we use to summary the networks. Therefore, to make the routing table of R3 has only 2 subnets we have to summary other subnets into one subnet.
In the output if we don't see the summary line (like 10.0.0.0/8 is a summary...) then we should use the command ip summary-address eigrp 123 10.2.0.0 255.255.0.0 so that all the ping can work well.
In conclusion, we will use the ip summary-address eigrp 123 10.2.0.0 255.255.0.0 at the interface s0/0 of R4 to summary.
R4> enable R4# conf t
R4(config)# interface s0/0 R4(config-if)# ip summary-address eigrp 123 10.2.0.0 255.255.0.0 Now we jump back to R3 and use the show ip route command to verify the effect, the output is shown below:
[ee2%255B5%255D.jpg]
Note: Please notice that the IP addresses and the subnet masks in your real exam might be different so you might use different ones to solve this question.
Just for your information, notice that if you use another network than 10.0.0.0/8 to summary, for example, if you use the command ip summary-address eigrp 123 10.2.0.0 255.255.0.0 you will leave a
/16 network in the output of the show ip route command.
[ee3%255B5%255D.jpg]
But in your real exam, if you don't see the line "10.0.0.0/8 is a summary, Null0" then you can summarize using the network 10.2.0.0/16. This summarization is better because all the pings can work well.
Finally don't forget to use the copy run start command on routers R3 and R4 to save the configurations.
R3(config-if)# end
R3# copy run start
R4(config-if)# end
R4# copy run start
If the "copy run start" command doesn't work then use "write memory".

QUESTION NO: 2
Which interface type does a PPPoE client use to establish a session?
A. Physical
B. Loopback
C. Virtual-template
D. Dialer
Answer: D
Explanation
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/bbdsl/configuration/xe-3s/bba-pppoe- client.html

QUESTION NO: 3
Which two types of threshold are configured for tracking objects? (Choose two.)
A. Percentage
B. Delay
C. Bandwidth
D. Administrative distance
E. Weight
Answer: A,E

QUESTION NO: 4
Which condition prevents the establishment of a DMPVN tunnel between two spokes?
A. HSRP is enabled on the spoke devices
B. IPsec is enabled on the spoke devices
C. The two spokes are behind different PAT devices
D. The two spokes have different tunnel keepalive settings
Answer: D

QUESTION NO: 5
The OSPF database of a router shows LSA types 1.2,7, and a type 3 default route only. Which type of area is this router connected to?
A. NSSA
B. NSSA totally stub
C. tub area
D. totally stubby area
Answer: A

SAP C-DS-43認定試験の準備を完了したのですか。 OMG OMG-OCUP2-ADV300 - 人生にはあまりにも多くの変化および未知の誘惑がありますから、まだ若いときに自分自身のために強固な基盤を築くべきです。 受験生が最も早い時間で、一回だけでCiscoのSalesforce Advanced-Administrator-JPN認定試験に合格できるために、NewValidDumpsはずっとがんばります。 HP HP2-I69 - そうすると、あなたがいつでも最新バージョンの資料を持っていることが保証されます。 NewValidDumpsのCiscoのHuawei H12-811試験トレーニング資料は正確性が高くて、カバー率が広くて、値段も安いです。

Updated: May 28, 2022