NewValidDumpsにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 300-101受験内容認証試験に参加する方に対して問題集を研究続けています。君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにNewValidDumpsを選択してください。NewValidDumpsはまた一年間に無料なサービスを更新いたします。 NewValidDumpsの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoの300-101受験内容認定試験対策模擬テスト問題集が研究しました。模擬テスト問題集と真実の試験問題がよく似ています。 NewValidDumpsの問題と解答は初めに試験を受けるあなたが気楽に成功することを助けるだけではなく、あなたの貴重な時間を節約することもできます。

CCNP 300-101 あなたは成功な人生がほしいですか。

いま300-101 - Implementing Cisco IP Routing受験内容試験に合格するショートカットを教えてあげますから。 ですから、NewValidDumpsの300-101 最新問題問題集の品質を疑わないでください。これは間違いなくあなたが300-101 最新問題認定試験に合格することを保証できる問題集です。

一回だけでCiscoの300-101受験内容試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。NewValidDumpsは君にとってベストな選択になります。ここには、私たちは君の需要に応じます。

Cisco 300-101受験内容 - NewValidDumpsはきっとご存じしています。

自分のIT業界での発展を希望したら、Ciscoの300-101受験内容試験に合格する必要があります。Ciscoの300-101受験内容試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoの300-101受験内容試験に合格することができます。Ciscoの300-101受験内容試験を準備しているあなたに試験に合格させるために、我々NewValidDumpsは模擬試験ソフトを更新し続けています。

あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。Ciscoの300-101受験内容認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。

300-101 PDF DEMO:

QUESTION NO: 1
Which interface type does a PPPoE client use to establish a session?
A. Physical
B. Loopback
C. Virtual-template
D. Dialer
Answer: D
Explanation
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/bbdsl/configuration/xe-3s/bba-pppoe- client.html

QUESTION NO: 2
JS Industries has expanded their business with the addition of their first remote office. The remote office router (R3) was previously configured and all Corporate subnets were reachable from
R3. JS Industries is interested in using route summarization along with the EIGRP Stub Routing feature to increase network stability while reducing the memory usage and bandwidth utilization to R3.
Another network professional was tasked with implementing this solution. However, in the process of configuring EIGRP stub routing connectivity with the remote network devices off of R3 has been lost.
Currently EIGRP is configured on all routers R2, R3, and R4 in the network. Your task is to identify and resolve the cause of connectivity failure with the remote office router R3. Once the issue has been resolved you should complete the task by configuring route summarization only to the remote office router R3.
You have corrected the fault when pings from R2 to the R3 LAN interface are successful, and the R3 IP routing table only contains 2 10.0.0.0 subnets.
Answer:
See the Explanation below.
Explanation
First we have to figure out why R3 and R4 can not communicate with each other. Use the show running-config command on router R3.
[eigrp10.jpg]
Notice that R3 is configured as a stub receive-only router. The receive-only keyword will restrict the router from sharing any of its routes with any other router in that EIGRP autonomous system. This keyword will also prevent any type of route from being sent. Therefore we will remove this command and replace it with the eigrp stub command:
R3# configure terminal R3(config)# router eigrp 123 R3(config-router)# no eigrp stub receive-only
R3(config-router)# eigrp stub R3(config-router)# end Now R3 will send updates containing its connected and summary routes to other routers. Notice that the eigrp stub command equals to the eigrp stub connected summary because the connected and summary options are enabled by default.
Next we will configure router R3 so that it has only 2 subnets of 10.0.0.0 network. Use the show ip route command on R3 to view its routing table:
[ee1%255B5%255D.jpg]
Because we want the routing table of R3 only have 2 subnets so we have to summary sub-networks at the interface which is connected with R3, the s0/0 interface of R4.
There is one interesting thing about the output of the show ip route shown above: the 10.2.3.0/24, which is a directly connected network of R3. We can't get rid of it in the routing table no matter what technique we use to summary the networks. Therefore, to make the routing table of R3 has only 2 subnets we have to summary other subnets into one subnet.
In the output if we don't see the summary line (like 10.0.0.0/8 is a summary...) then we should use the command ip summary-address eigrp 123 10.2.0.0 255.255.0.0 so that all the ping can work well.
In conclusion, we will use the ip summary-address eigrp 123 10.2.0.0 255.255.0.0 at the interface s0/0 of R4 to summary.
R4> enable R4# conf t
R4(config)# interface s0/0 R4(config-if)# ip summary-address eigrp 123 10.2.0.0 255.255.0.0 Now we jump back to R3 and use the show ip route command to verify the effect, the output is shown below:
[ee2%255B5%255D.jpg]
Note: Please notice that the IP addresses and the subnet masks in your real exam might be different so you might use different ones to solve this question.
Just for your information, notice that if you use another network than 10.0.0.0/8 to summary, for example, if you use the command ip summary-address eigrp 123 10.2.0.0 255.255.0.0 you will leave a
/16 network in the output of the show ip route command.
[ee3%255B5%255D.jpg]
But in your real exam, if you don't see the line "10.0.0.0/8 is a summary, Null0" then you can summarize using the network 10.2.0.0/16. This summarization is better because all the pings can work well.
Finally don't forget to use the copy run start command on routers R3 and R4 to save the configurations.
R3(config-if)# end
R3# copy run start
R4(config-if)# end
R4# copy run start
If the "copy run start" command doesn't work then use "write memory".

QUESTION NO: 3
The OSPF database of a router shows LSA types 1.2,7, and a type 3 default route only. Which type of area is this router connected to?
A. NSSA
B. NSSA totally stub
C. tub area
D. totally stubby area
Answer: A

QUESTION NO: 4
Which two types of threshold are configured for tracking objects? (Choose two.)
A. Percentage
B. Delay
C. Bandwidth
D. Administrative distance
E. Weight
Answer: A,E

QUESTION NO: 5
Which condition prevents the establishment of a DMPVN tunnel between two spokes?
A. HSRP is enabled on the spoke devices
B. IPsec is enabled on the spoke devices
C. The two spokes are behind different PAT devices
D. The two spokes have different tunnel keepalive settings
Answer: D

あなたは自分の望ましいCisco SAP C_TS462_2022-KR問題集を選らんで、学びから更なる成長を求められます。 我々は力の限りにあなたにCiscoのHuawei H40-111試験に合格します。 現在IT技術会社に通勤しているあなたは、CiscoのSAP C-ACT-2403試験認定を取得しましたか？SAP C-ACT-2403試験認定は給料の増加とジョブのプロモーションに役立ちます。 我々NewValidDumpsの提供するCiscoのServiceNow CIS-CSM試験のソフトを利用した多くのお客様はこのような感じがあります。 人によって目標が違いますが、あなたにCisco　ECCouncil 312-96試験に順調に合格できるのは我々の共同の目標です。

Updated: May 28, 2022