NewValidDumpsはずっと君のために最も正確なCiscoの200-301過去問題「Cisco Certified Network Associate Exam」試験に関する資料を提供して、君が安心に選択することができます。君はオンラインで無料な練習問題をダウンロードできて、１００％で試験に合格しましょう。NewValidDumpsはIT試験問題集を提供するウエブダイトで、ここによく分かります。 我々200-301過去問題問題集の通過率は高いので、90％の合格率を保証します。あなたは弊社の高品質Cisco　200-301過去問題試験資料を利用して、一回に試験に合格します。 Cisco 200-301過去問題「Cisco Certified Network Associate Exam」認証試験に合格することが簡単ではなくて、Cisco 200-301過去問題証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。

あなたは200-301過去問題試験のいくつかの知識に迷っています。

NewValidDumpsのCiscoの200-301 - Cisco Certified Network Associate Exam過去問題試験問題資料は質が良くて値段が安い製品です。 200-301 日本語版トレーリングはCiscoのひとつの認証で、200-301 日本語版トレーリングがCiscoに入るの第一歩として、200-301 日本語版トレーリング「Cisco Certified Network Associate Exam」試験がますます人気があがって、200-301 日本語版トレーリングに参加するかたもだんだん多くなって、しかし200-301 日本語版トレーリング認証試験に合格することが非常に難しいで、君は200-301 日本語版トレーリングに関する試験科目の問題集を購入したいですか？

NewValidDumpsのCiscoの200-301過去問題試験トレーニング資料はIT人員の皆さんがそんな目標を達成できるようにヘルプを提供して差し上げます。NewValidDumpsのCiscoの200-301過去問題試験トレーニング資料は１００パーセントの合格率を保証しますから、ためらわずに決断してNewValidDumpsを選びましょう。Ciscoの200-301過去問題認定試験は実は技術専門家を認証する試験です。

Cisco 200-301過去問題 - 夢を持ったら実現するために頑張ってください。

Cisco 200-301過去問題認証試験に合格することが簡単ではなくて、Cisco 200-301過去問題証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。

さて、はやく試験を申し込みましょう。NewValidDumpsはあなたを助けることができますから、心配する必要がないですよ。

200-301 PDF DEMO:

QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

Huawei H12-811-ENU - NewValidDumpsが持つべきなIT問題集を提供するサイトでございます。 NewValidDumpsのWGU Secure-Software-Design教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。 Salesforce Revenue-Cloud-Consultant-Accredited-Professional - でもたくさんの方法があって、最も少ない時間をエネルギーをかかるのは最高です。 Microsoft SC-100J - ところで、受験生の皆さんを簡単にIT認定試験に合格させられる方法がないですか。 NewValidDumpsのCiscoのVMware 2V0-41.23-JPNの認証したカバー率は１００パーセントに達したのですから、弊社の問題と解答を利用する限り、あなたがきっと気楽に試験に合格することを保証します。

Updated: May 28, 2022