200-301科目対策 資格取得

NewValidDumpsのCisco 200-301科目対策問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。我々200-301科目対策問題集の通過率は高いので、90%の合格率を保証します。あなたは弊社の高品質Cisco 200-301科目対策試験資料を利用して、一回に試験に合格します。 Cisco 200-301科目対策「Cisco Certified Network Associate Exam」認証試験に合格することが簡単ではなくて、Cisco 200-301科目対策証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。 一年間で更新するなる、第一時間であなたのメールボックスに送ります。

CCNA 200-301 その夢は私にとってはるか遠いです。

CCNA 200-301科目対策 - Cisco Certified Network Associate Exam しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。 さて、はやく試験を申し込みましょう。NewValidDumpsはあなたを助けることができますから、心配する必要がないですよ。

弊社が提供した問題集がほかのインターネットに比べて問題のカーバ範囲がもっと広くて対応性が強い長所があります。NewValidDumpsが持つべきなIT問題集を提供するサイトでございます。

Cisco 200-301科目対策 - 試験に失敗したら、全額で返金する承諾があります。

全てのIT専門人員はCiscoの200-301科目対策の認定試験をよく知っていて、その難しい試験に受かることを望んでいます。Ciscoの200-301科目対策の認定試験の認可を取ったら、あなたは望むキャリアを得ることができるようになります。NewValidDumpsのCiscoの200-301科目対策試験トレーニング資料を利用したら、望むことを取得できます。

暇な時間だけでCiscoの200-301科目対策試験に合格したいのですか。我々の提供するPDF版のCiscoの200-301科目対策試験の資料はあなたにいつでもどこでも読めさせます。

200-301 PDF DEMO:

QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

それはNewValidDumpsのCiscoのSymantec 250-585試験トレーニング資料は適用性が高いもので、本当にみなさんが良い成績を取ることを助けられるからです。 我々NewValidDumpsはCiscoのWGU Secure-Software-Design試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。 Cisco 500-442 - NewValidDumpsを選んだら成功を選んだということです。 たとえば、ベストセラーのCisco ISC CISSP問題集は過去のデータを分析して作成ます。 NewValidDumpsはIT認定試験に関連する資料の専門の提供者として、受験生の皆さんに最も優秀な試験CompTIA CV0-004J参考書を提供することを目標としています。

Updated: May 28, 2022

200-301科目対策 - 200-301模擬トレーリング、Cisco Certified Network Associate Exam

PDF問題と解答

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-04-24
問題と解答:全 950
Cisco 200-301 全真問題集

  ダウンロード


 

模擬試験

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-04-24
問題と解答:全 950
Cisco 200-301 復習時間

  ダウンロード


 

オンライン版

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-04-24
問題と解答:全 950
Cisco 200-301 過去問題

  ダウンロード


 

200-301 対応資料