200-301問題と解答 資格取得

200-301問題と解答問題集を手に入れる前のサービスであれば、アフタサービスであれば、弊社はお客様の皆様の認めを得られるために、皆様の質問をすぐに返答できて準備しています。我々の社員は全日中で客様のお問い合わせをお待ちしております。あなたはNewValidDumpsの200-301問題と解答問題集について、何の質問があると、メールで我々のメールアドレスに送ったりすることができます。 今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。NewValidDumpsが提供したのオンライン商品がIT業界では品質の高い学習資料、受験生の必要が満足できるサイトでございます。 多くの人々はCiscoの200-301問題と解答試験に合格できるのは難しいことであると思っています。

CCNA 200-301 「信仰は偉大な感情で、創造の力になれます。

CCNA 200-301問題と解答 - Cisco Certified Network Associate Exam 弊社の商品が好きなのは弊社のたのしいです。 あなたの夢は何ですか。あなたのキャリアでいくつかの輝かしい業績を行うことを望まないのですか。

NewValidDumpsはもっぱらITプロ認証試験に関する知識を提供するのサイトで、ほかのサイト使った人はNewValidDumpsが最高の知識源サイトと比較しますた。NewValidDumpsの商品はとても頼もしい試験の練習問題と解答は非常に正確でございます。

Cisco 200-301問題と解答 - 試験に失敗したら、全額で返金する承諾があります。

NewValidDumpsのCiscoの200-301問題と解答「Cisco Certified Network Associate Exam」試験トレーニング資料はPDFぼ形式とソフトウェアの形式で提供して、NewValidDumpsのCiscoの200-301問題と解答試験問題と解答に含まれています。200-301問題と解答認定試験の真実の問題に会うかもしれません。そんな問題はパーフェクトと称するに足って、効果的な方法がありますから、どちらのCiscoの200-301問題と解答試験に成功を取ることができます。NewValidDumpsのCiscoの200-301問題と解答問題集は総合的にすべてのシラバスと複雑な問題をカバーしています。NewValidDumpsのCiscoの200-301問題と解答テストの問題と解答は本物の試験の挑戦で、あなたのいつもの考え方を変換しなければなりません。

我々もオンライン版とソフト版を提供します。すべては豊富な内容があって各自のメリットを持っています。

200-301 PDF DEMO:

QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

Palo Alto Networks PCNSE-JPN - 人々は自分が将来何か成績を作るようにずっと努力しています。 我々NewValidDumpsはCiscoのMicrosoft MS-700試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。 Oracle 1z1-808-KR - あなた自身のために、証明書をもらいます。 たとえば、ベストセラーのCisco HP HPE6-A85問題集は過去のデータを分析して作成ます。 HP HPE0-V25J - 現在のIT領域で競争が激しくなっていることは皆は良く知っていますから、みんなはIT認証を通じて自分の価値を高めたいです。

Updated: May 28, 2022

200-301問題と解答 & Cisco Certified Network Associate Exam最新資料

PDF問題と解答

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-05-05
問題と解答:全 950
Cisco 200-301 試験過去問

  ダウンロード


 

模擬試験

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-05-05
問題と解答:全 950
Cisco 200-301 合格対策

  ダウンロード


 

オンライン版

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-05-05
問題と解答:全 950
Cisco 200-301 英語版

  ダウンロード


 

200-301 復習対策