200-301入門知識 資格取得

弊社のCiscoの200-301入門知識試験問題集を買うかどうかまだ決めていないなら、弊社のデモをやってみよう。使用してから、あなたは弊社の商品でCiscoの200-301入門知識試験に合格できるということを信じています。我々NewValidDumpsの専門家たちのCiscoの200-301入門知識試験問題集への更新と改善はあなたに試験の準備期間から成功させます。 これは試験の準備をするために非常に効率的なツールですから。この問題集はあなたが少ない労力で最高の結果を取得することができます。 我々はあなたのCiscoの200-301入門知識試験への成功を確保しているだけでなく、楽な準備過程と行き届いたアフターサービスを承諾しています。

CCNA 200-301 そうだったら、下記のものを読んでください。

私たちを見つけるのはあなたのCiscoの200-301 - Cisco Certified Network Associate Exam入門知識試験に合格する保障からです。 NewValidDumpsのCiscoの200-301 模擬問題集問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。もし不合格になったら、私たちは全額返金することを保証します。

あなたは不幸で試験に失敗したら、我々は全額で返金します。NewValidDumpsは成立以来、ますます完全的な体系、もっと豊富な問題集、より安全的な支払保障、よりよいサービスを持っています。現在提供するCiscoの200-301入門知識試験の資料は多くのお客様に認可されました。

Cisco 200-301入門知識 - NewValidDumpsの問題集は最大のお得だね!

NewValidDumpsにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 200-301入門知識認証試験に参加する方に対して問題集を研究続けています。君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにNewValidDumpsを選択してください。NewValidDumpsはまた一年間に無料なサービスを更新いたします。

機会が一回だけありますよ。いまCiscoの200-301入門知識試験問題のフルバージョンを取ることができます。

200-301 PDF DEMO:

QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

NetSuite NetSuite-Financial-User - もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。 NewValidDumpsはあなたが次のCiscoのCisco 200-201認定試験に合格するように最も信頼できるトレーニングツールを提供します。 Amazon SAP-C02-KR - あなたに成功に近づいて、夢の楽園に一歩一歩進めさせられます。 Oracle 1z1-808 - 当社の資料はあなたがIT専門家になるように特別に受験生の皆さんのために作成したものです。 Microsoft SC-200 - 試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。

Updated: May 28, 2022

200-301入門知識、Cisco 200-301試験解答 - Cisco Certified Network Associate Exam

PDF問題と解答

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-04-19
問題と解答:全 950
Cisco 200-301 試験問題集

  ダウンロード


 

模擬試験

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-04-19
問題と解答:全 950
Cisco 200-301 資料勉強

  ダウンロード


 

オンライン版

試験コード:200-301
試験名称:Cisco Certified Network Associate Exam
最近更新時間:2024-04-19
問題と解答:全 950
Cisco 200-301 全真模擬試験

  ダウンロード


 

200-301 復習時間