古く時から一寸の光陰軽るんずべからずの諺があって、あなたはどのぐらい時間を無駄にすることができますか？現時点からNewValidDumpsの074-335勉強ガイド問題集を学んで、時間を効率的に使用するだけ、074-335勉強ガイド知識ポイントを勉強してMicrosoftの074-335勉強ガイド試験に合格できます。短い時間で074-335勉強ガイド資格認定を取得するような高いハイリターンは嬉しいことではないでしょうか。 NewValidDumpsの試験トレーニング資料はMicrosoftの074-335勉強ガイド認定試験の１００パーセントの合格率を保証します。近年、IT領域で競争がますます激しくなります。 我々社のMicrosoft　074-335勉強ガイド試験練習問題はあなたに試験うま合格できるのを支援します。

Microsoft Lync Server 074-335 だから、私たちは信頼されるに値します。

Microsoft Lync Server 074-335勉強ガイド - Network Readiness and Assessment for Lync 気楽に試験に合格したければ、はやく試しに来てください。 もしあなたはまだ合格のためにMicrosoft 074-335 全真模擬試験に大量の貴重な時間とエネルギーをかかって一生懸命準備し、Microsoft 074-335 全真模擬試験「Network Readiness and Assessment for Lync」認証試験に合格するの近道が分からなくって、今はNewValidDumpsが有効なMicrosoft 074-335 全真模擬試験認定試験の合格の方法を提供して、君は半分の労力で倍の成果を取るの与えています。

ここには、私たちは君の需要に応じます。NewValidDumpsのMicrosoftの074-335勉強ガイド問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。もし不合格になったら、私たちは全額返金することを保証します。

Microsoft 074-335勉強ガイド - 君の初めての合格を目標にします。

NewValidDumpsのMicrosoftの074-335勉強ガイド試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。その権威性は言うまでもありません。うちのMicrosoftの074-335勉強ガイド試験トレーニング資料を購入する前に、NewValidDumpsのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。君がうちの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

IT業界ではさらに強くなるために強い専門知識が必要です。多くの人々は高い難度のIT認証試験に合格するのは専門の知識が必要だと思います。

074-335 PDF DEMO:

QUESTION NO: 1
You need to determine the minimum Asymmetric Digital Subscriber Line (ADSL) network service requirements for the branch locations.
Which bandwidth should you choose?
A. l Mbps/512 Kbps
B. 5 Mbps/1 Mbps
C. 5 Mbps/1.5 Mbps
D. 10 Mbps/3 Mbps
Answer: C
Explanation:
/ Branches should be able to support up to 24 simultaneous peer-to-peer (P2P) calls between sites /
Fabrikam uses RTAudio Wideband (57Kbps)
24 x 57 = 1368. For redundancy, the backup line must be at least 1368kpbs, ie: 1.5Mbps.

QUESTION NO: 2
Your company corporate telephony environment is a combination of Lync 2013 and traditional
Private Branch Exchange (PBX). The company has 3,500 users at three sites that use a Multiprotocol
Label Switching (MPLS) topology. On average, the company has 3 percent of its users dialing in for conferences and 7 percent on a public switched telephone network (PSTN) call at any time.
The company plans to remove the PBXs and have all users use only Lync 2013. The company also plans to migrate from an existing content sharing platform.
You need to generate a persona by using IP-based unified communication (UC) scenarios.
Which three pieces of information should you collect when you are defining a persona for the existing communications? (Each correct answer presents part of the solution. Choose three.)
A. conference sessions
B. voice codec used
C. PSTN-to-PSTN sessions
D. peer-to-peer (P2P) sessions
E. content sharing
Answer: A,D,E
Explanation:
User Guide Microsoft Lync Server 2010 and 2013 Bandwidth Calculator

QUESTION NO: 3
Your company corporate telephony environment is a combination of Lync 2013 and traditional
Private Branch Exchange (PBX). The sites are connected by a Multiprotocol Label Switching (MPLS) topology. There are 750 users who are using Lync 2013 and 2,500 users who are using the PBX environment. On average, the company has 10 percent of its users in conferences. The company plans to add additional bandwidth for all sites.
The company is concerned about the number of dropped calls on the PBXs.
As part of a bandwidth upgrade process, you model real-time transport protocol (RTP) media call flows for audio communications. You have determined the average number of calls and estimated the bandwidth required for the audio portion of the calls.
You need to identify the additional bandwidth requirements when modeling real-time transport control protocol (RTCP) traffic.
Which bandwidth option should you choose?
A. 5 kilobits per second (kbps) per stream
B. 20 kilobits per second (kbps) per stream
C. 5 kilobits per second (kbps) total
D. 20 kilobits per second (kbps) total
Answer: A
Explanation:
RTCP Bandwidth Media RTCP maximum bandwidth (Kbps)
Audio 5
Video 10
An Introduction to Network Assessment Concepts: Microsoft Unified Communications

QUESTION NO: 4
HOTSPOT
You analyze the results of Lync traffic modeling for a customer's network. The relevant portion of the network topology diagram is shown in the answer area.
The estimated links workload is shown in the following table:
The customer wants to build a highly available Lync infrastructure.
You need to determine which link must be updated to support the customer's requirements.
Which link should you update? (To answer, select the appropriate link in the network topology diagram.)
Answer:

QUESTION NO: 5
You need to deploy and enable Quality of Service (QoS) on all workstations to meet the planned changes and performance goals. Which three actions should you perform? (Each correct answer presents part of the solution. Choose three.)
A. Apply Service Pack 3 to all Windows XP workstations and Service Pack 2 to all Windows Vista workstations.
B. Create Group Policy objects (GPOs) for Lync audio and video and configure them to use the same port ranges and Differentiated Services Code Point (DSCP) values for QoS.
C. Create Group Policy objects (GPOs) for Lync audio and video and configure them to use different port ranges and Differentiated Services Code Point (DSCP) values for QoS.
D. Configure the Group Policy object (GPO) configuring QoS and set it to Enforced.
E. Upgrade all Windows XP and Windows Vista workstations to Windows 7 or above.
Answer: C,D,E
Explanation:
Note that Microsoft Lync Server 2013 does not support QoS for other Windows operating systems, such as Windows Vista or Windows XP.
The port ranges and DSCPs must be different for audio and video. To create a Quality of Service audio policy for Windows 7 or Windows 8 computers, first log on to a computer where Group Policy
Management has been installed. Open Group Policy Management (click Start, point to Administrative
Tools, and then click Group Policy Management) and then complete the following procedure:
- In Group Policy Management, locate the container where the new policy should be created. For example, if all your client computers are located in an OU named Clients then the new policy should be created in the Client OU.
- Right-click the appropriate container and then click Create a GPO in this domain, and Link it here. - I n the New GPO dialog box, type a name for the new Group Policy object in the Name box (for example, Lync Audio) and then click OK. - Right-click the newly-created policy and then click Edit. - I n the Group Policy Management Editor, expand Computer Configuration, expand Policies, expand
Windows Settings, right-click Policy-based QoS, and then click Create new policy.
- In the Policy-based QoS dialog box, on the opening page, type a name for the new policy (e.g., Lync
Audio) in the Name box. Select Specify DSCP Value and set the value to 46. Leave Specify Outbound
Throttle Rate unselected, and then click Next.
- On the next page, make sure that All applications is selected and then click Next. This setting instructs the network to look for all packets with a DSCP marking of 46, not just packets created by a specific application.
Etc.

ACAMS CAMS-KR - 時間とお金の集まりより正しい方法がもっと大切です。 Cisco 300-710J - 自分の練習を通して、試験のまえにうろたえないでしょう。 MicrosoftのIBM C1000-181試験を準備しているあなたに試験に合格させるために、我々NewValidDumpsは模擬試験ソフトを更新し続けています。 UiPath UiPath-ABAv1 - それは確かに君の試験に役に立つとみられます。 Fortinet NSE7_LED-7.0 - 世の中に去年の自分より今年の自分が優れていないのは立派な恥です。

Updated: May 28, 2022